Recent Activity

Activity stream for all registered members at VFRworld.

  1. sixdog replied to the thread 1990 VTR250.

    Cap … what pop t did you use for the “power chamber “ ? I know that part of the exhaust gets super hot . Sent from my iPhone using...

    May 8, 2026 at 4:13 PM
  2. RogueRC24 replied to the thread VTR 2fiddy parts bike.

    For less confusion, the bike did not come with carbs. These were off ebay. I will use the hawk manual to perform surgery. So to clarify...

    May 8, 2026 at 3:52 PM
  3. squirrelman attached a file to the thread VTR 2fiddy parts bike.

    [ATTACH] it might be the cable end stuck in place ? show cable end its a round cyinnder with a pointed end 2 or 3mm wide pushed by a...

    12-1-17_057.JPG.87ea93e0a41ac78c6d965fef019506a3.JPG May 8, 2026 at 2:33 PM
  4. RogueRC24 attached a file to the thread VTR 2fiddy parts bike.

    Also, since I am disconnecting the cal can, do I need to access the air/fuel screw that they seal? Maybe I am not describing it right. I...

    image.jpg F919548F-16BF-4531-9038-04AE8C56E12B.jpeg May 8, 2026 at 1:59 PM
  5. RogueRC24 attached a file to the thread VTR 2fiddy parts bike.

    I am pulling apart the carb and this highlighted thing is where the choke cable goes into. It just spins without going in or out. How...

    092BC7C1-AE26-4468-A2D9-338070E74778.jpeg May 8, 2026 at 1:17 PM
  6. Bazza liked Aaron Richardson's post in the thread Bike for Sale 1999 VFR 800 for sale in Va.

    Thinking about moving my '99 VFR 800 on. It's absolutely excellent, but it's one of nine bikes in our stable, and things that can handle...

    Front left 3:4.jpg Front right 3:4.jpg Fairing close left.jpg Fairing close right.jpg May 8, 2026 at 11:46 AM
  7. Bazza liked Captain 80s's post in the thread Brake caliper pistons.

    Ahh. They do, and they have a nonmetallic pad in there, that's why I asked. Sounds like you're set!

    May 8, 2026 at 11:45 AM
  8. Bazza liked Prime Target's post in the thread Brake caliper pistons.

    I used new pistons from Brake Crafters. I didn't see any caps on them. The old pistons still have the caps. I didn't think they came off...

    May 8, 2026 at 11:45 AM
  9. Alan H has a new avatar.

    May 8, 2026 at 10:55 AM
  10. sixdog liked RogueRC24's post in the thread VTR 2fiddy parts bike.

    VFR day in Monterey! Capt can try out Laguna if he hasn't already been.

    May 8, 2026 at 10:43 AM
  11. sixdog replied to the thread VTR 2fiddy parts bike.

    Yea Sent from my iPhone using Tapatalk

    May 8, 2026 at 10:43 AM
  12. RogueRC24 liked Prime Target's post in the thread Brake caliper pistons.

    Front brake master disassembly and reassembly. The outer piston seal was leaking but the internal seals still looked good. Snap ring...

    IMG_3973.JPEG IMG_3974.JPEG IMG_3975.JPEG IMG_3976.JPEG IMG_3977.JPEG IMG_3978.JPEG May 8, 2026 at 10:33 AM
  13. RogueRC24 replied to the thread VTR 2fiddy parts bike.

    VFR day in Monterey! Capt can try out Laguna if he hasn't already been.

    May 8, 2026 at 10:32 AM
  14. Aaron Richardson liked mello dude's post in the thread Bike for Sale 1999 VFR 800 for sale in Va.

    Very nice 5th gen! Good luck with the sale...:thumbs:

    May 8, 2026 at 10:14 AM
Loading...