Carb Sync Procedure - 3rd Gen

Discussion in 'Mechanics Garage' started by rogersj3, Jun 10, 2011.

Page 3 of 3
  1. ridervfr

    ridervfr Member

    Country:
    Belgium
    Joined:
    Dec 26, 2009
    Messages:
    4,048
    Likes Received:
    144
    Trophy Points:
    78
    Location:
    South FL
    Map
    Looks better than an "Evo" :hippie: :peace:
     
    ridervfr, May 30, 2015


    This site may contain affiliate links for which VFRworld may be compensated
    #41
  2. THRASHED

    THRASHED New Member

    Country:
    United States
    Joined:
    May 13, 2015
    Messages:
    135
    Likes Received:
    3
    Trophy Points:
    18
    Location:
    San Dimas, CA
    Map
    Float seats and needles arrived yesterday. On the mix screws, pulled all four, cleaned passages (including removing the broken tips from three of them), replaced the broken screws, and replaced o-rings. Busy the next day or so but hopefully I'll try to get it started soon.
     
    THRASHED, Jun 2, 2015


    This site may contain affiliate links for which VFRworld may be compensated
    #42
Page 3 of 3

Share This Page