Took the carbs apart again. Replaced everything inside with the bits in the carb rebuild kit. Seems to run fine now.
OK, it starts every time now, but the idle is really erratic. I'll start it with choke and it will immediately go to 4000 rpm. Pull the choke...
Well, I guess the starter was just "stuck". Once it decided to crank, it stared right up. Guess what I'll be doing this weekend.
They were definitely stuck. I soaked them in a jar of Rocket Chemical Company's finest, but they wouldn't budge. I replaced them, and now have...
Two of the float valves are stuck to their respective float bodies. I believe the assembly number is: 16011-MT4-000. Looks like $40 each, if I...
OK, I'm getting fuel to the #3 and #4 carbs (right side). What am I missing?
Yes, that didn't do anything. I've got the carbs off now and looking for a blockage in the fuel lines. Either that or maybe I mixed up the fuel...
Yes, as I mentioned previously, I pulled the hose off of the output, bypassed the relay and got a steady stream of fuel out of it. So I'm gessing...
Thanks for the help. I never noticed those. I took one out, no gas came out. I'm guessing that's a bad thing. I'll put the tank back on and...
Someone posted a picture of the carbs two messages up. Could you point out where the drains are? And is it possible to access them with the...
I've heard about the carb drains, but I don't see them. I've tested the fuel pump per the service manual, and it pumps out plenty of fuel....
I have a 1991 VFR 750 that I've had for 10-12 years. Sometimes it sits too long, won't hold idle so I clean out the carbs and everything is OK....
Hi all: I have a 1991 VFR 750 that I don't ride often enough and I guess gas gums up the carburetors and it won't hold idle. I've taken them...
Do you recommend a carb rebuild kit? If so, which one? Or is it enough to take the carbs apart and clean them?
Any ideas what to try? I get it started, hold it at 3 or 4000 RPMs for a few minutes and it sounds fine, but when I let go of the throttle it...
That was it. Fixed. Peace out...
I think that might be it. 25 mm diameter, 10 mm thick.
It fell out just in front of the rear wheel. Any idea where it goes? I just changed the brake and clutch fluid, that might have something to do...
Hi All...I have a 1991 VFR and the throttle seems to stick a bit. So: 1. Should I oil the throttle cables with like 30W oil or something? I've...
Thanks. Any suggestions for holding the bike up with the front wheel off? It doesn't have a center stand.
Separate names with a comma.
