Partzilla has OEM seals (and most other rubber parts).
Back in '85 I switched to DOT 5 in my VF750 when I put braded lines on. Fast foward to 2015 when I restored the 83 after sitting for 25 years (...
Where is yours showing heat damage? At the connectors or the wires? I believe the heavier wire just has thicker insulation because it goes through...
Anytime there are signs of heat, it is due to resistance in the connection. Burnish the connectors in the fuse holder and the pins on the fuse....
Try holding camera 180 degrees
Don't know about other states, but CA has both the VIN & Engine Number on the registration. On the VFR's engine # is on back side of engine block,...
Since it is more than 20 years old, I would check all ground points and connectors for corrosion. Wire brush or sand connections.
Contact your card issuers and have them get you new cards.
RE: the mattress, I make it a point never to ride (or drive) behind pick-ups and cars with any tied down or floating around in the bed. People are...
I asked my cat if he would like a Border Collie too: [IMG]
I have had 4 Dalmations over the years, but I think I would like a Border Collie next time, not enough room right now inside or outside.
I love these literal translations! however, I did run into a "festive dog" the other day! Heading up one of my favorite roads I saw a Border...
I think you should inspect all the rubber parts, especially the carb boots. Ozone & polution will harden most all the seals, o-rings, tubing just...
Separate names with a comma.
