stretch the stock springs to 8"- 8 1/2" lubricate slides with WD-40 and clean the area where they slide with green Scotchbrite and WD-40...
idling at lights and stop-and-go traffic NORMALLY cause rise in temperature , and your bike is doing fine. as long as fan comes on and system is...
if you remove the round access cover at end of crankshaft (on clutch cover) you can turn the engine with a 17mm socket.......no electricity needed.
time to try SeaFoam to clear carb jets.
try turning up the idle adjustment screw to boost idle speed
ANOTHER thing: test the upper and lower fork bushings for excess play or wear
MAyBE pEOple should be allOWed to drive 1 mile-an-hour faSter for every yEar they havE bEen driVing, stARtinG at 18..... ThAt way,...
VERY typical storage problems fuel dripping would be one sign or not running right on one cylinder in hotter storage regions the float bowl...
when a bike has been sitting for a long time the clutch plates can stick together, and if tranny is in any gear the bike wants to move...
loosen but don't remove the front axle, the bottom fork pinch bolts, the upper clamp pinch bolts,and large steering stem nut.... then stand in...
glad you found it. this exact problem is common across the range of Honda 'cycles, but the problem is in the starter switch. are u sure you...
there is a technique to brake the clutch loose while riding but it requires bravery and coordination and luck......but i don't want to be liable...
IT'S also the introduction to a costly NEW ADDICTION: sticky tires, lots of them.....
I have a Telefix on one of my '86 700s hard to quantify improvement, but easy to feel: better control in cornering. installation must be done...
YOU'RE READY FOR 20K SERVICE :: remove, clean, inspect, regrease and install or REPLACE upper and lower steering bearings. The Service...
NOW that's a FIRST: a Nigerian got scammed by an American!!
i'm thinkin' it would be hard to fool PumaCat on photoshop since he's a PRO!
who told you that?? what does HE ride?? some heap from 1928 ??
pressure washers are good for dirt bikes, not street bikes. the potential for water damage and corrosion is lots higher with pressure, so just...
Separate names with a comma.
