the exact answer to that excellent question is in your Honda service manual.
OH, I LOVE A MYSTERY !! and this IS one!! I don't think it's possible to install bearings too tight or wrong ...as long as they are fully...
Always suspect plugs first, but you changed them this summer??? so is it summer in Canada already, mon frere, eh? it's your blinkin' fuel...
high idle may be an intake air leak. is the bike running on all 4 cylinders 30 seconds after you start it ?? ?? touch each exhaust pipe to...
AND HOW..... how is this relevant to VFR riders, huh??
I'd NEVER do that trade!! Just look at the Fi problem posts, the thermostat issues, the wiring harness recalls, etc, YOUR simpler '96 will...
You're very generous with your time and electrical knowledge here GHOST, something really needed cuz Honda electrics ain't the best.
the 7mm is when float tang JUST CONTACTS lightly, not depresses the plunger.
I recently had ocasion to study a melted ('84 VF 700) wiring harness and can state, after post-mortum forensic examination, that Honda mistakenly...
That's right: your clutch is not releasing fully, most likely due to old clutch fluid and air in the system. Forcing the shift pedal into gear...
FEAR NOT ! it's all easy, man, once you have some experience..... bench bleed is far quicker than full system bleed...all you need is brake...
IF that fork oil hasn't been changed in a few seasons ......it may be dirty and done wo' out ! measure the springs when you remove fork caps to...
WELCOME ! so what year VFR would that be?? heat transfer to frame is normal. on a new- to- you bike , always flush the cooling system ,...
Want LOTS more improvement?? Go to steel braided brakelines, and your lever will feel like you're squeezing a brick, while it feels now like...
probably already stated, but i'd be looking for bad grounds now and adding new ones. you can push to force a new wire into the green wires at...
tried closing the bleed screw to get pressure? it helps to let it sit for a day or 2 and bubbles will rise up to MC....
What is the mission you hope to accomplish? Please state what year and model bike?? Just to change out old brake fluid ( it should be...
the filter should be pre-filled by hand about 2/3 full before installation, and it's always best to crank the engine with the RUN switch OFF until...
First you need to determine by measurement and close inspection what new parts you need, and then you need to find them......not easy on that old...
Obviously, you've checked the condition and pressure (with an accurate gauge) of the tyres?? checked or changed fork oil and steering bearings?
Separate names with a comma.
