Chinese haven't yet figured out quality control; just look carefully at any Chinese-made scooter. They only make things aimed at the lowest...
At 38k you're probably due for bearing replacement, both headset bearings AND wheel bearings. don't cheap out with chinese junk like Allballs;...
Since frames are very different engines would probably not swap easily.
Generally, jetkit needles are custom made for the application and can't be purchased except in the kit. Do some searching; stepping up the...
Dennis Kirk sells EMGO.....1-800-969-7504 or DennisKirk.com - Motorcycle, Harley-Davidson, ATV, Dirt Bike, Snowmobile, PWC / Watercraft Parts,...
Also don't remove the cable holder and idle screw from the carbs.....
could be cracked starter clutch, yes.......
Ferro veccio......time 4 a new bike, even if it's not a Honda. Too mucha lira to rebuilda that tired old motore, ill motore she say "Basta!"
HOW does someone order a new 2006 bike in 2009???
"VD" series
INCORRECT. When a pulse generator develops an open circuit it fails at all rpms. They can be fine on startup, then fail shortly after the...
THAT'S cool! Whoda ever thunk that info would be collected ?? I remember a made for TV movie ( but don't recall the title) several years...
My first VTR 250, an '88, had those girly colors, white, teal and pink, but the pink was a sticker, which i peeled off with a heat gun, and i...
THAT'S right. With numbers that low there's something seriously wrong with the bike or the dyno.......or both.
NOW, only now years later can we fully appreciate the utterly prophetic wisdom of our esteamed philosophical advisor in starting this thread....
VOICE of "Stewie" from Family Guy: OH, my GAWD, a Goldwing Trike !! I MUST have one so that everyone will know what an olde endomorphic...
A well cared for stock original chain from Honda usually lasts about 20,000 miles b4 it starts getting troublesome......
OK, mostly i ride one of my '86 700s or Hawk GTs, and those bikes have a very easily reached idle screws, so i didn't know about the difficulties...
I believe it would be permissible to fill any unwanted hole with JB Weld, and it would hold up fine cuz it's not submerged in gasoline......
Actually the dynojet kit instructs you to use a drill bit ( which they supply) to simply enlarge ( by a very small amount) the existing hole on...
Separate names with a comma.
