Good guesses ! Steering bearings loosen up over mileage, might need re-tightening, are usually shot and need replacement by 40k miles, could be...
>>>>>>Do it the right way and the sensible way, order from K&L Supply, about $22 approximately for set of 4<<<<<<< Can't find my shit or i'd...
Sender= cheap-i$h Gauge= u don't wanna know !! $$$$$$$
I rode that exact route a couple times, and it's one of AZ's best circle rides !! Yarnell Hill very exciting !! But watch for cops !...
BRIEFLY !! very BRIEFLY or the gauge can be ruined !! Totally, utterly ruined ! A low coolant level that is below the sensor will give erratic...
What's worst about engine braking is that it adds considerable HEAT to a motor that tends to run warm anyway. not something for a hot day, just...
OH, yeah, the VF 500 has the potential to be a good bike, but probably not one that comes in boxes......that you got free !
.......seems those flashing hazard lights should have given you some clues and slowed you down..... alot. given your description of the scene,...
Synch is no fun on these bikes, trying to find a small screw with the tip of a screwdriver from the bottom up, in a narrow, hot , darkish place!!
A bit of intense research on our excellent site will help you decide, starting with a search of "VF 500 valve issues." Question is: do you want...
IMO the VFR is a great bike but not a great first bike. It's a bike you should graduate to from something smaller. Being a big guy should...
That's something you need to try.....boost idle to 1100 rpm, change oil to 20W-50, hope the light goes off.
:welcome: How many miles ?? ........most honest advice i could give is to get rid of the bike as soon as possible while it still runs. oil...
BOTH cables should have slack between the cable holder bracket on the carbs and the throttle wheel.....
You said the cables had minimal slack, right?? One common cause of problems with throttle cables is not enough slack, so try using the cable...
Honda : Interceptor : eBay Motors (item 170459842502 end time Mar-22-10 18:01:45 PDT)
Good advice; i offer a similar but slightly different suggestion: AFTER axle is tightened and b4 left side pinch bolts are secured, it helps...
Check charging voltage after new battery is installed.....should measure between 13.5 and 14.5 DC volts @ 5000 rpm. But first check battery...
HONDA service manuals are GREAT help when routing wires, hoses, cables, etc. with very clear line drawings to follow. Make sure the rubber...
:welcome: Great bike......AND it has a centrestand, right !!!!!!! What year ?? Not much ever goes wrong with the antidive unless someone...
Separate names with a comma.
