^^^^ what he said !
Our ole Don has his peculiarities, don't he ?? Of course the dang thing both regulates as well as rectifies the voltage; otherwise the output...
Most fuel filters have directional arrows or IN and OUT markings, so you need to confirm that it's flowing in the correct direction. If pump...
Don, where did you get this specious misinformation, and why did you, with all your experience believe it ?? I have 5 or 6 bad VFR/VTR...
Why didn't anyone mention a possibly clogged fuel cap vent as a cause ?? Initial post pointed unquestionably toward low fuel level in carbs, so...
Just plan on replacing both bearing sets with OEM parts. Once the balls have worn and the races have a groove worn into them the setup can't be...
It's easy to make your own manometer set for about $5 in materials, and you can find directions on-line.
Probably just trickle it into each carb throat after pulling the air filter. While you're in there, you should check that each vacuum slide moves...
Oversteer ?? Crank out 1/2 turn of wedge, add a spring rubber, and pull a strip of tape off the grill.
WELCOME !!!! For the speedo problem look at both the cable and the drive unit on the front wheel. Most common issue is broken cable. If the...
You got a great deal there !! Besides finding bodywork, my biggest concern would be what kind of damage was done to frame, swingarm bearings,...
Yep, Heatmizr was smart and talented enuff to get his ass out of Buffalo, and i admire him for that. But, Bunkie, get real: any litre bike is a...
So, you, sir, are in the best position to tell us all whether the 2 carb sets are actually interchangable !
Sand, bondo, sand again and repaint, and shut up cuz i'm a bigger idiot than you, and I testified to that in traffic court once, under oath so you...
True dat: "Something else to ride you dont have to work on. "
Pull the 2 wires off the switch ( if they didn't fall off in the tip-over) and test with an ohmmeter. You should have continuity with the lever...
Gen 1 ?? You think the engine is OK ?? Inspected the cam lobes ?? Look at a parts fische (sp?) to see what's missing, a few springs most...
Impossible to do the job right without vaccum readings from all 4 cylinders simultaneously.
A DWELL tach, as i remember, is primarily used to check for proper points gap on a old-fashoned ignition system, but let's wait for our #1...
Slave rebuild parts consist of 2 seals, cheap, easy to do. Mityvac is more of a crutch than a cure-all. Best clutch bleed is done by removing...
Separate names with a comma.
