Take your voltmeter along when you go to see the bike.:eek:
On the rare occasions when i do clean the white wheels on an '86 700, i use Go-Jo hand cleaner scrubbed in with a toothbrush, then rinse with a hose.
You can change the position either by adjusting the threaded rod or by turning the connection on the engine one or 2 splines after removing the...
Voltage is good So both r/r and stator check out fine. So trouble is a bad battery or loose, corroded or non-functional plug or ground wire...
New seals wound be the next thing to try, mc first. If you or a PO waS acting hooligan, there could be warped clutch plates. Test mc by...
pilot jet cleaning..... Note that there are 2 axial holes that need to be clear. [ATTACH][ATTACH]
If the plug on top of the starter relay is metled/burned, that can also cause non-charging.........but it's usually the r/r !
ZX-14, Hyabusta, V-Max, 1198, etc.: nobody needs or can use that kind of power !! Unless it's just for bragging about........ THINK SMALL
"Last longest" usually means less braking power, dunnit ?? If i want brakes that stop hard, how long the pads last is not so important. Be...
As Dukie suggests, just sitting for a week or 2 is sometimes enough to clog slow jets with our corn-infused fuel, so get in there again and put a...
Why not buy new seals for about $12 and rebuild it ??
The far better alternative to riding on a plugged tire is to fit a PLUG/PATCH from the inside of the tire after you get home.
Not only bleed the system but change out the old fluid entirely. You might possibly need to replace seals in MC or slave cylinder.
Have you tried running the bike up to top speed ?? A good test of carbs !
Harbor Freight torque wrench ?? Whatever, probably Chinese. As ridevfr sayeth, your judgement, based upon experience, is usually more reliable...
Pull the carbs off, and check that all the throttle plates just begin to open at the same time (bench synch) or set up guages and try a proppa...
Ben, it (#7) slides in the only way it slides in. Be sure to spin the rear wheel by hand after installation and after the axle nut is torqued...
Oh, yeah !! A bike as fast as a V-Max pushes motorcycle power to seriously dramatic proportions. Kinda like sitting on top of a built...
Stock original chains are usually in need of replacement by 25-30,000 miles.
Dennis Kirk catalog shows dozens of mirrors......
Separate names with a comma.
