Man, that's scarey...........and amazing it didn't make more noise ! Somehow, to my eyes, the sprocket bolts look way too close to the arm, so...
I'll venture just one guess since you have covered almost everything. I'm no FI expert, but if something were holding open the throttle so it...
Glad u fixed it soon b4 it snows up there......eh ?
Sitting in traffic on a hot day, yes, 3/4 scale is normal. Fan should switch on at anything over that.
Is it possible that the bottom fork bolt is leaking (someone didn't replace the washer) onto the rotor ??
Correct....!
A new headlight bulb, some wire and electrical or duct tape, fuses, along with the toolkit. Spare R/R too if you have one.
Look at the screw bottoms, and if they're seriously mashed and distorted, it's hard to adjust clearances; so see if you can replace them or only...
You sure it's not from leaky fork seals?? Anti-dive leakage is seriously unusual, and probably a result of its being taken apart and assembled...
That's unusually, impossibly low miles to need clutch replacement :crazy:, so expect other signs of PO abuse or incompetence.:frown: It's not a...
Best not to assume the cooling system is full, so another check under the rad cap after your first ride and a top up when the engine is cool is...
Rock the RUN/OFF switch back and forth a few times. How's battery voltage ? It's not hard to get access to rear cylinder plug wires, so do your...
It's essential to clean/probe/poke wire through the side holes on the main jet holder tube when doing a carb clean.
Setting clearances (not tolerances) can be done as long as the cam lobes are pointing AWAY from the valves and on the back of the cam, whether the...
OR just use an old plug you carry in the tool tray........... If one coil quit, the bike would still run, just missing on one cylinder. Have you...
If YOU don't buy it I WILL:redface:................
General rule of thumb: Always have a look at the sparkplugs FIRST anytime there's a running or starting problem. And NEVER use sandpaper on...
That could easily be your problem !! Caps don't last forever as rubber gasket may crack or harden, spring weaken over time. It's amazing that...
That could be float levels set too high, resulting a low level of fuel in carbs. Or just filthy carbs, idle jets and their associated passages...
Sounds like a brilliant solution to me ! I trust my educated wrist better than any torque wrench for smaller screws/bolts. It saves a alot of...
Separate names with a comma.
