DN-01 innit ??
What is a VFR 500 ???
No worries. Compression may even out after you ride it a bit. Check the valve clearances on that low cylinder.
Test it again at operating temperature. 125 psi cold is OK, i believe.
Yes, the axle should have wheel bearing grease applied, but not on the bolt/nut. Should use a torque wrench when tightening unless you're very...
How long did it sit inactive before the test ?? How many miles on the engine ??
Steering head bearings...... May need readjustment about 500 miles after replacement.
Just eliminate the relay by bypassing it, using an insulated jumper wire at the relay plug.
Testing off the bike can be inconclusive, confusing. Just plug it, start the bike, and see if charging voltage is within proper range ! Test...
That's the best possible education for a VF500 rider !!~
I wouldn't ride my VFR anywhere except in town without a 12v test light or small multimeter, a length of wire, and electrical or duct tape.
:welcome: You might be able to polish out the pits with #1000 sandpaper ?? What do you have your degree in ??
:welcome: It ALWAYS helps to state the mileage on your bike. A good-quality chain lasts about 20,000 miles, and worn chains usually have a...
Right !! A bad thermostat that doesn't allow the engine to get to it's optimum temperature will waste fuel, just like a failed sensor will.
[ATTACH] Dial gauges cuz i gottem free.......
Try new sparkplugs.
Good example of previous LACK of proper maintenance since coolant changes and flushes should be routine every few years and would have prevented...
You should have about 120 psi cold and 180 hot on an engine in good shape. No easy fix.
you say the starter runs as soon as a battery is hooked up ?? Should only run when start pushbutton is pressed, so u have a problem with the...
:welcome::cool::party:
Separate names with a comma.
