Wet plugs track voltage to ground, won't fire. maybe using too much choke ?? Try initial cranking with choke halfway, not fully on, and leave...
Try adjusting the clip or adding a washer to tune out the flat spot. Experimentation and a few carb r&r's may be needed. With dyno time and...
Bad synch won't be responsible for bogging down. The jet difference you mentioned F/R is more than usual. I'd suggest removing air filter and...
What's it set at now ?? :help: :biggrin1: That would be a good starting point if u don't have specs. Maybe same as the VF500 setting....
U got dat right brudda !:eagerness: Yes they might. Newish seals tend to be OK after storage, but very often old ones dry up, shrink in size...
I must dissent. :eagerness: That assertion is far from completely accurate itself as a properly-done hand-and-eye bench synch is usually capable...
Did this one get fixed ?? :triumphant:
[ATTACH] YA TALKIN TA ME, ya lil pissa ??
If clutch is slipping high revs don't match high speed. What speed do you have at redline in top gear ?? :crazy:
There's a very fine Honda manual to answer your query.
I like forgot, like totally forgot about this entertaining and educational thread !!!!!!!!!!!!!!!!!!!!!! :party2: :party: Introducing Cheeki,...
Sure, it's slow if you just got off a V-Max or ZRX !!!! What was it running like before your :nelson::nelson: repairs ?? :party2: And exactly...
Drain carbs for storage longer than 3 weeks. Cold starts are hell on bearings, pistons, rings, cylinders and cause excessive wear, so you need to...
Best for bleeding to remove sprocket cover (or slave) and hold the piston fully retracted by means of a C-clamp. And always allow an air space...
Keep Kool, Mites !!:eagerness: Any chances that inferno could move into Sydney proppa ??
Not so bad, now drivers seem to give me more space on the road and stay farther back at stoplights.
Did the plugs you removed all look similar in color ?? [ATTACH] You can check that cylinders are firing by lightly touching each header pipe...
You're maybe missing some screws ?? Go fisching :grumpy: Studying the FSM should help you find the problem. :party2:
This is the tool used on the Hawk that also works on a VFR..... [ATTACH] (Roundtail ground squirrel included for scale)
You're missing a ground wire or attachment to +12 volts. Giving up the running light function up front with cheepo indicators isn't a good...
Separate names with a comma.
