Try getting the rear wheel up and spinning it over while you try to shift up and down. shifting is easiest when engine and rear wheel are both...
Sorry, but really, RVFR, Jan 9 post, isn't it redundant to write "so hence"................? Surely, "hiccup" is one word. :Eek: Check the OED,...
u sure no spacers or washers are missing ?> o_O
Belissima ! Milano is my favorite Italian city because it's the home of Alfa Romeo ! [ATTACH]
I PM'ed (conversated) you.
that melting is not very uncommon. [ATTACH]
I have a complete, clean gen3 engine (compression tested good) for sale in classified, $300 + shipping. Carbs also available, cleaned and ready...
don't use an impact driver on an axle. you ought to be able to put the required 65ft-lbs on with a socket and a 2 1/2' breaker bar. place the...
Try removing the MC from the bar and hold it vertical with the lever at the high point while tapping MC and lines.
You'll need to replace the starting system lockout diode for sure.
yes, after 1 or 2 days the bowl gaskets may swell and seal again. you'll need to keep gas in the bowls by pushing the starter button occasionally.
OK, but be sure not to adjust the chain too tight. :rolleyes:
Any bike that tries to pull your arms off the bars at max acceleration or one that finished 3rd at the 1986 Daytona 200 and won its class in AMA...
As with any newly-purchased used bike, drain and flush the fuel tank before trying to start.
Probably over-tightened. :confused:
Nothing special about it, must be corroded, use penetrating oil + heat. or use impact driver.
Crush washers may be bad. the more you bleed the mc, the crusheder they get.
Please check your PM's for my offer to repair your carbs ;)
An NC35 deal my buddy set-up online that took 2 months to arrange and many weeks to happen........... (latest version). My buddy and shopmate...
Separate names with a comma.
