There are several USB outlets available, I've had several.... some need a hole, some need a surface mount or handlebar mount or..... a zip tie or...
You really should go to a more direct power source. I have used a combo USB/voltmeter that has a switch on it, reasonably accurate, hardwired...
None whatsoever. The originals suck. If you want the screw type (1/4 turn to release), look up the ones for FJR1300 side panel/gas tank trim....
A long time ago I gave up traditional power sockets, they're too big and bulky. Hard wire what you can, but coax heated gear outlets are small...
Well, somebody's going to have some fun!
Datels back in the day were the best in the game and reasonable (~$12??)... new ones are ~$30+. I still consider them the best and most...
Just an FYI, from my experience on older cable driven Hondas, the drive may be OK but the cable has at one point seized and broken not far up the...
I'm sure we could get into another "oil" thread with coolant, but I like simple. My preference is to use a brand name long life/5 year coolant...
Datel has a cheap one? Ha. I have collected a few samples from China and will decide which to mount. I like direct wiring w/switch so I can see...
2song, get that thing in song and sing your way a few miles west for coffee. I had a VF1100C back in the day....... welcome aboard.
I use Prestone long life/5 yr. 50-50 premix, which is silicate free, ~$10/gal. No 2 year stuff for me, but OK if you want to.
Just from what I know about PAIR systems... it's a passive system to let ambient filtered air into the exhaust ports, air is drawn in by negative...
Thanks, Terry, I did get all the O-rings also.........
Any little 1/8-1/4" helps, but perhaps take a lesson from dirt/adventure riders whose seats are way higher than their inseam..... slide forward at...
If you're mechanically inclined, follow the manual and all will be good. Take pics and remember where stuff goes and it's not that hard on any...
The JB Weld stuff is too runny for my liking and not as strong.
About to tackle this myself, have OEM thermostat and a set of AES silicone hoses. Valve check will be done also.
Permatex Plastic Epoxy. Tough, sandable, paintable.
This was at the Toronto Motorcycle show a coupla weeks ago...... part of club's exhibition. [IMG]
Separate names with a comma.
