read, study, follow carb cleaning steps in honda service manual, and find a youtube or two. asking questions is encouraged here
if you find a pinhole-sized leak JBWeld is a reliable fix. :cool: JB:Cheer2:JB:Cheer2:JB :Cheer2: three cheers:Bounce: saved our cheap asses...
somethings way, way wrong. do you actually know where the idle mixture screws are located ? not the float bowl drain screws......... soaking is...
mixture screws set at about two turns out ? dija clean idle jets properly ? [ATTACH] did you reset float levels ? [ATTACH]
test for proper action of the slides [before mounting carbs] by blasting low pressure compressed air into the oval-shaped section on intake side...
it helps to have a manual switch in parallel so you have more control and can activate the fan to prevent temp from rising too fast.
two signs of a growing charging problems [ATTACH] [ATTACH]
you need to get idle to about twelve hundred rpm
if your diaphragm is in good condition youll hear an air puff as you lift the slide with a finger. leave originals in place if they work.
---"My 1986 VFR700F2 wouldn't rev up beyond a certain point. The problem ended up being the top rubber vacuum diaphragms. My fault, as I didn't...
'es our number one 'lectrickal expert, 'e is. :emporer: [and modest too]
please post if you find they're available and where. lets see close-up photos of the screw bottoms, ok ? ive seen some messed-up wear on...
remove and inspect the bottoms of the adjusting screws. any visible damage or signs of wear, replace them. [i dunno if theyre available ?...
^^ i did a few laps [on my blue hawk] there during az bike week years ago, just off an air force base runway. [ATTACH]
side holes need to be probed with wire [ATTACH]
they always claim they cleaned the carbs first time, second and third time, sometimes still not right. :eek: hard to clean properly unless one...
check slides by blasting air into the oval-shaped hole on carb. if one or more slide fails to rise the bike wont run right. as fuel level in...
the bike had a fuel pump when new, and you need to find and plumb one in, NOT gravity feed. remove the airbox top and check that each vacuum...
you set pilot screws not pilot jets. there is no correlation between noise and mixture screw settings that i know of. check that the spring,...
Separate names with a comma.
