Getting a VFR to the point where you can remove and install the carbs is fairly tedious. If you don't know when (IF!) the fuel tube crossover...
The Radian is/was such a great bike. Looking at that photo I'm surprised it won't come out after the carbs. Fairly un-Yamaha-like. Side note:...
Red rubber grease and a heat gun. If they feel like they are "usable", they will pop in with those two ingredients. Really should not use...
On an old bike where the plastic is brittle, if one cracked or deformed badly and I had a good replacement... think I would care all of a...
It's not the engineer's problem. The high volume air box CAN be replaced. Just follow the steps listed in the GSXR Service Manual after Engine...
I think he means there is no way to manipulate / rotate it to clear the frame and engine and slide out. It's a Suzuki... I wouldn't be surprised.
Yeah I've seen that one. I rather clean brake fluid out of the caliper than grease.
I think hydraulics still hooked up. bmart, the old crusty, nasty shit we work on laughs at compressed air. I have an old master cylinder...
Hell yes, good story.
I think Airtech makes one out of glass. Also check Beasley Composites.
I raced at Portland International Raceway a couple times. One weekend was WET. I mean POURING AND BLOWING wind. In a race on my 500 they...
My Barnett bikes have always stuck a bit after sitting.
With this many bikes I can't afford, time and money, to do all the maintenance at the same time. It has to be a rolling schedule. For winter...
A little late, but shuffling bikes for Winterizing. 95 VFR off the lift after doing the deed. First Gear Drive Carb VFR next to the last......
Yep, except I typically try some abrubt on/off throttle cycles as it gets warmed up.
Killah
Awesome
Should work just fine. Might be a tad thick for some spots but should compress nicely.
It sounds like your clutch plates are frozen together, and it can happen on bikes that have sat, usually long periods, but some bikes can do it...
#13 is your cartridge holder with top-out spring and the tube at the top connects to your fork cap to pull fluid for rebound dampening. If your...
Separate names with a comma.
