Nice! I'd be happy with that.
Third last pic..... would that not be your adjustment for fast idle on the end of the FIWV? When cold of course...
The well-nuts are pretty universal... 5 mm thread and fit into a certain size hole (that I'm too lazy to go out and measure... 10mm??). The other...
I'd also check all the fuses. Normally fuel pump does not run if... fuses related to FI are blown/bad contact, sidestand down in gear or kill...
I haven't used any kits... note some are aluminum. By rubber spring locks, do you mean rubber well-nuts that expand as you tighten... I usually...
Check your owner's manual..... mine says 86, but in North America "regular" is 87... I have seen 85 in the US, never 83. I don't think you'd have...
Perhaps consider you can have the title copied and reproduced, nicely framed where you can showcase it....???
I would test the stator before soldering that all up..... just in case. Mine is burned up pretty good too but the stator is still good.... mofset...
Spec. is .012 +/- .001, so perfect.
What clearances did you find? Did you rotate the engine and check more than once? Was the feeler free to move in/out/around or snug?
They never get looser, only tighter.
No both looser rather than tighter. I realized in my post I forgot to add the words 'of max', so I edited it, and added another comment at the...
Dayum! You're gonna like that triple!
Duct Tape can't fix stupid, but it sure can muffle the sound!
What I usually do if I have to pull the cams anyway, re-shim or swap shims to get clearances slightly above nominal, i.e, 60-70% of max....
:worthless: Congratulations!! Pictures would be nice.
It's useful to know the state of battery charge, ignition off and no headlights on..... certainly OK to have it switched if you're just monitoring...
There are several USB outlets available, I've had several.... some need a hole, some need a surface mount or handlebar mount or..... a zip tie or...
You really should go to a more direct power source. I have used a combo USB/voltmeter that has a switch on it, reasonably accurate, hardwired...
None whatsoever. The originals suck. If you want the screw type (1/4 turn to release), look up the ones for FJR1300 side panel/gas tank trim....
Separate names with a comma.
