A woman awakes during the night to find that her husband of 20 years is not in bed. She puts on her robe and goes downstairs to look for him. She...
If the pedal is going down easily, master may not be primed, loosen banjo at the MC and let gravity leak a little out then snug it back up. Once...
Dirt bike OK as they max out at 300 lbs. I wouldn't go any heavier, certainly not a VFR. I walk a bike up two ramps, but make sure they are tied...
Seems you've got a simple misalignment... all good advice above, but loosen the fork pinch bolts in the triple tree, straighten it up and snug the...
Had the same problem... pull the rod out, make sure it's clean and put a bit of grease on the end... in she goes. My guess is it gets hung up on...
Agree with you Cherryriver, the PIAA's adequate, better than the single, don't take up a lot of room. Had them on both FJR's. Wing horns, oh...
Have you got the clip out? You could be all day if you don't, lol. Heat is your friend if you do.
PIAA has small format sport horns, dual or single. I think my 5th Gen horn is fine.... got good connections, etc.??
Back in the day... ran one for 3 years.
No slippage.......... As for oil, I recommend you use some. Motorcycle specific would be just fine.
I'd say pick either, both look good to me....... The wax motor is the auto cold start as you call it.........
Welcome! Doesn't matter about the cold start, I prefer the lever too but I'd be Ok with the wax motor too.
If you were using a charger with desulphation mode, that 'splains the 14+ you saw while charging.... shoulda dropped down to 13.2-ish after that...
Main battery ground to engine or frame?
Sounds normal to me. Thermostat spec start to open is ~180F, fully open ~203F. No spec listed for fan engagement, but if it comes on at...
What Grum says........ Does the 6th Gen have a ground spider (not on the wiring diagram) and main chassis ground like the 5th Gens? If so,...
Awesome!
The injectors and coils share a common ground coming from the ECU.... which receives its ground from the chassis ground on the right side of the...
Yes, that...... but you mention valve adjustment..... are the cams in time or perhaps a tooth off?
I can't really comment except to say I'd have to see it myself. I'd pull the clutch apart and see what's working and not working..... e.g., is...
Separate names with a comma.
