Agree, gotta look at that master cylinder again.... it all starts there.
It's likely the master cylinder didn't prime... you can try to open the bleeder at the slave and let gravity do it's work for a few minutes, or,...
Excellent news! Always put your Johnson to good use, lol. As you know, aluminum and steel can have bi-metal corrosion.. .. a wee bit of...
I don't even worry about dropping the VFR, to me, it's a light bike in comparison to my former sport tourers. However, there was a dumshit moment...
A few years ago Walmart SuperTech brake cleaner had MEK in it. MEK will eat any kind of plastic and paint, would be good for loctite. I thought...
Try a pencil torch on the bolt head perhaps, but yes the aluminum is a big heat sink. In any case, have a fresh new bit and a manual impact...
I have much experience with woodworking tools...... as Norm Abram said on New Yankee Workshop, 'never can have too many routers". I have 5. You...
I would also recommend having your battery load tested. A dying battery can cause your issues.
There's an old saying...... He who dies with the most tools wins!!
Won't that be a little tough to mount on the shaft drive, lol? I don't need one of these, I'd need one for each bike 'cuz I'm lazy and wouldn't...
Booze is high in calories.... if each drink is ~150 calories, read up on what it takes to burn that off.... The equation is: calories burned =...
Cool stuff here......... https://www.poppystore.ca/
I'd suggest making a permanent food intake change, as if you were diagnosed diabetic or Type2 diabetic. Forced change if that happens to you.......
[ATTACH]
As much as we dislike politicians, doesn't matter who's in there, you can't please everybody. It's been going on long before the current...
I read this and thought you found your hub......... yes or no? On Partzilla, I see the nut, washer and dampers showing as available. What are you...
If it were me, while the axle nut is off, time to dissassemble the entire rear end, check bearings and give them a good greasing before putting it...
The PO may have had the final drive apart and perhaps didn't torque properly and stake the nut.... the hub shouldn't be too far from where you...
You lost the whole hub and everything? Rear axle nut came loose somehow... wasn't staked?? Yep f-ing lucky in a few ways... Your hub and...
Worked on an '86 about 4 years ago while visiting a buddy... had a miss at idle.... not enough time to dig in deeper, but we got it running...
Separate names with a comma.
