I can check my SM later, but I'm pretty sure the rear? A little richer for the potentially hotter rear cylinder bank?
Essentially everything should be interchangeable (at least from production 83 750 to production 84 700) And we need pictures.
Living in the NW... Ferry mode. In gear, roll forward till resistance, then side stand. If super paranoid... zip tie front brake lever with...
1st of all... WTF? Never heard of that. Just order by part number. They don't know what bike you are ordering for. 99101-MBZ-1250...
I think if everything is properly setup, you will be very happy with 42 pilot, 125 main and .020 under the needles. It will run sweet. In my...
What is their recommendation based on? I have stock cams in stock heads, stock airbox, and stock headers with a 4-1 slip on. I chose 122 on my...
Got some news, Squirrel... [ATTACH]
Since I don't have any dyno charts to post, all I can go on is 20+ years building, riding and racing VFs and VFRs and finding out what works for...
83-85 VF700/750F carbs will work. 49 state and California. You will have some vents to plug on a California set and the jets will be slightly...
The jets I used are genuine Honda Keihin. You can take the Honda part #s for those jets and change to what size you need. Take a look, you'll...
Your clutch plates are likely just stuck together from sitting. Pretty common. Couple ways to try and un-stick them without dis-assembly. Get...
Yes, Fuel mixture screws / pilot screws... same thing. Fuel screw > spring > washer > oring. You accounted for all of them when you had the...
When you remove the pilot screws for carb cleaning, each one has a spring, washer and o-ring. If you do not know what I am referring to, then a...
On my 86 700 with a 4 into 1, I went with 125 mains, 42 pilots and the stock needles shimmed up using the same washers as the pilot screws have in...
The master cylinder issue he is most likely talking about is not necessarily unique to the bike or master cylinder. There is a tiny hole in the...
Your jetting might be on the lean side considering you have a 4-1 slip on exhaust. And you should not get any pressure release when opening the...
On the 49 state bikes (which is what yours looks like due to the open carb vents), the tank bents through the gas cap. They can get clogged and...
That is just a vent hose, not vacuum. Sounds like you need to do a more thorough carb clean and make sure all passages are clear. Your idle...
4-1 not my first choice on these V4s, but I couldn't believe it was a buy it now.
CR500s can smell fear. They will take your ankle out and drive your knee into the the throttle tube.
Separate names with a comma.
