He sure is, within his specialty,the best here with shocks and springs, etc. But he won't touch carbs with a 10 foot pole, so there's SQUIRRELMAN...
Nuts ?? :party: [ATTACH]
Agree with above ^^^as a likely cause. Or maybe a sensor, somewhere ? No code flashes ?? It's your FI, kid,:nelson: so either get used to it or...
Hold on, cowboy; that ain't right !! In order to actually control idle speed the adjustment screw MUST come to rest touching the stop.
Counter-clockwise is a richer idle mix. Instead of using book specs that are set for low emissions USA standards, most VFRs run better at lower...
Just what i always suggest: wheelies are for fools, showoffs, and kids too stupid to perceive danger.
Project bike missing plastic but runs OK. 1986 honda VFR 750f Not mine but i have seen it.
Fuel can get into the crankcase when you drop the bike due to carb overflow, not any piston ring problem.
Sitting for that long with a bad petcock allowing fuel into carbs, they probably need a proper cleaning. Ether is death to piston rings, pistons,...
STARTER clutch would make that noise. No balance shafts, you mean the transmission countershaft. Leak could also be from slave cylinder or clutch...
They're all like that, kid ! :homer: If you want to try a VFR with impressive pull below 5000, find an earlier carbed 750.
Drain and flush the cooling system using a product that cleans. Possible build-up with pockets of sludge around that cylinder, reducing heat...
An epoxy liner like the fuel tank sealer from Plating Kits Electroplating Kits Aluminum Anodizing Kits Powder Coating Systems Metal Polishing And...
Always a good idea to thoroughly clean rotors with spray and scuff them up with #400 sandpaper when changing pads.
Time to loosen, clean, sand, and re-tighten the main ground wire connection.
No, please !! We're G-rated here.
Possible damage to START button maybe ?
With blockages, u need more cleaning. Idle jets need wire-probing to assure fuel can pass through, and idle mixture screw passages need carb...
AS K-B suggests, it might be a good plan to clean the carbs first, paying attention to idle jets and idle mixture screw passages. Note that the...
Separate names with a comma.
