Little late... just confirming. Screw on engine side of carb: Fuel Screw on airbox side of carb: Air Never seen one differ.
2014 VFR800 2017 Africa Twin DCT 2017 Suzuki M109R BOSS 2012 CBR125R Repsol 2007 Aprilia RSV1000R Factory 2000 ZRX1100 1988 Hawk GT647 RC31 1986...
Can you thread an adapter, like one used for carb synch in vacuum parts? Probably a lot of work to come up with something decent. Would be nice tho.
Maybe time for some clear tubes while they are still out? At lest to get them consistent with each other. Maybe when the bowl is installed,...
Slightly more so when they don't have a Wing on them. Keep on keepin' on stray. [ATTACH]
If he can meet you, he can meet a dude in a Sprinter Van. Doesn't have to do shit except stand there after rolling the bike out.
I shipped my 95 VFR from New Jersey to Seattle for $400. They had a "I don't care how long it takes" discount option.
We would be so far apart I wouldn't even bother. This market is stupid right now, I wouldn't be over $2000. Not even close. Its not even low...
[ATTACH]
Oh and you certainly don't HAVE to remove that much to do steering head bearings. I don't even take off the upper cowl when I do them. I just...
That 8mm-head bolt looks wrong for that location. The correct bolt is a round hex that is flush in the bracket when installed. You may have...
I reuse the lock washer no problem. I bend the tabs up just enough and bend em right back down at assembly. I don't think I could go thru enough...
I was going to clean the carbs and run the bike to video it and try and sell the engine with carbs, harness and ECU. If the motor is not good,...
That's awesome. Very cool! A 94 with 93 RWB bodywork has been on a desired list for a LONG time. The just Red and White from 91 is a looker...
After removing the old races with a long drift, cut a slot in them and use them as the interface to drive the new races in. Sometimes you dont...
A couple times in the past when adjusting float height I've thought, "that can't be right". So I hook up a clear tube to the float bowl drain and...
That's the first time I've ever heard that, regardless of make. Sounds like some old "wisdom" that got perpetuated from a self proclaimed...
I've ran into that before where the sketch is not based on reality. But it makes you scratch your head and doubt yourself sometimes.
I think they are saying the same thing you actually did. "Invert" until the float arm is just in contact with float valve.
Separate names with a comma.
