If there is any semblance of brake pressure, before undoing the lines, I will remove the pads and pump them out (adding fluid to the res as I go)...
Glad you got it sorted. It was really the only explanation as you seemed very capable of reassembling a clutch pack. When you took apart again...
Yeah, really dont think so. Pretty sure where it engages the mid and lower cowls is different. I'll be able to show for sure later as I'm...
I had an instance on a VF750F where I used the Viton o-rings I source on the float bowls. Because they are not the taller square type oring like...
7 x 2 mm for the fuel tubes. I buy them in bulk. I don't expect any issues, but I have never put them on the alum tubes. I have purchased and...
Yeah, tough spot. Nobody has those bikes over here, except for you, so there aren't any trail blazers. Post up which piece you need. Is it a...
I have never investigated. You are looking for something compatible with the 88/89, yes?
Confirmed. Even earlier in your thread somewhere.
Jesus Fucking Christ
I would have. I recently had the opportunity to buy a brand new one (in Granite Blue) for $100. Cowl pad not included, but still a screaming...
https://www.ebay.com/itm/334599133238?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=H7kg0u2XQoe&sssrc=2047675&ssuid=LzvmA6LrRpe&widget_ver=artemis...
This stuff is awesome. I've found the 2-part reaction can get hot enough to slightly melt (weld) the parts together on some plastics, as well as...
A good 2-part plastic weld epoxy or ABS glue would work great as well.
You won't find an intact example like this at that price again likely. Pretty rare. Sometimes the upper and lower "halves" which are spot...
I hate these kind of answers, but... Then don't worry about it. These bikes are certainly not known to fail in that area and there has been...
Most of those bikes that had problems, usually would have shit themselves already at that mileage. BUT, seriously take the time and inspect the...
The Hydraulic Brake section of the Honda Service Manual I'm looking at now has a picture of the backside of the footpeg bracket assembled. Think...
I don't have a picture, but the switch sits in a small steel bracket that is held with the bolt(s) that attach the rear master cyl to the footpeg...
https://www.ebay.com/itm/314059636805 No broken mounting tabs on this, which is rare. Price is very good.
Separate names with a comma.
