I really suspect that if you look at the parts fische, there will only be one part number listed. The question doesn't sound appropriate. I'm...
Does not sound like the person understood what you were looking for. I'm sure your troubleshooting process is a long story but I'll be curious if...
Look who's talking :P
Wife and I are booked in over at the Hampton Inn Paso Robles Am prepared to take piles of shit for loading the bike in the back of the truck and...
think nothing of it. no worries :thumbsup:
won't see them when the plastic is installed and any more time spent in the garage with this thing and I'm liable to find myself in divorce court....
possible plugged tank vent? It's rare but people say it happens. pull the fuel line off the carbs and do a fuel flow test. Factory service...
^^ well he seemed a lot bigger than your normal rabbit until I went back and watched the video Here's my mounting of the RR. Had to drill a hole...
I wouldn't put money into hard to find float needles at this point. If the bike was flooding out from leaking needles then it would likely take...
I have a harbor freight cheapo wheel balancer. for a VFR rear wheel, you need a spud that fits the backside. The harbor freight tapered bushing...
when it's cranking and firing; what happens when you roll on the throttle? Does it quit firing or does it take off. If the thing isn't getting...
answer to the question: http://vfrworld.com/forums/1st-2nd-generation-1983-1989/30282-vf500-engine-serial-number.html keep in mind, just because...
Took her out for a first run tonight and had a close call http://youtu.be/WqXSls7iO7M
factory manual says 163lbs sorry I don't have a motor outside of the frame at this time to get any accurate measurements.
Got my start with the V4 the same way. Good luck and welcome to the forum
quite common on the 500. Valve stems and cam lobes are weak points. Wait around and you'll find another parts bike for $500 and might get enough...
If you're going to put money into a 500, you just have to do it with open eyes and know what you are getting in to. Be glad to see someone do...
have you tried taking an eye dropper or something of the sort and pouring an ounce or two of fuel directly down all four carbs and see if it will...
your problem is the passage fed by the orifice in the non removable pickup tube. mechanic in a can will not open plugged orifices. And there's...
:tongue2: [IMG]
Separate names with a comma.
