i recommend you keep the new chain oiled properly so it doesn't look rusted like the old one. i apply oil with a paintbrush and push the bike...
leaving the old chain in position makes it useful to thread the new chain in so you don't need to remove the front sprocket cover [and deal with...
i usually check fuel levels on carbs sent to me for cleaning. lower photo shows my reference point, the seam between carb and float bowl measured...
our member GRUM is the foremost expert on matters electrical and a fellow-countryman of yours. try unplugging all the things on that bad circuit...
the only SURE way to check or top up coolant is under the radiator cap [when the engine is cold] as there are a couple of reasons why the...
cranking with car running.........could damage your charging system. have you checked your charging system output across battery terminals ? you...
WELCOME ;) nomenclature, please: it's a VF1000F or VF1000R :pipe: not a VFR1000, OK ?
much more rugged-looking and solid, easier to work on than earlier versions, although i'm no fan of the revised mixture screw. :( [ATTACH]
my buddy's HF unit crapped out after about 6 uses.......:deadhorse:typical junk from china.
oh, boy, this is classic.....................:eek:
24 oz beer can squashed flat. :drink: [12oz is for kids, 16oz just a start] please dispose of can in an environmentally responsibly manner in...
it's difficult to switch out throttle plates without bending the shaft, so b careful, and use locktite on the screws.
is there an interesting story behind to your need for fairings ? :rolleyes:
changing oil won't fix your problem. o_O
makes your bike look like a deco 50s kitchen appliance.
.....all this chasing after batteries, charging system, starter, etc. could have been solved alot earlier if you hadn't made false assumptions...
power to headlights goes through START button, could be dirty contacts in there ?
wait a minute ......... were you squeezing the clutch while pushing ? normally, cylinder compression will make pushing fairly hard.
shorter one goes into waterpump, i'm 90% sure.
more things to test...... you could also check for free engine rotation by pushing in gear or by popping off the right side access cover and...
Separate names with a comma.
