Whelp sorry to tell you, the first one didn't fit, and the second one didn't fit either until I ground down the cent stand. But the two brothers...
Hmmm Measure the diameter of the primaries with a micrometer and post up your findings. Then we'll know for sure. Sent from my iPhone using...
No fabrication is needed if you have a 3rd, 4th or 5th generation Vfr. The only reason I did any fabrication is because I have a sixth gen and Two...
By the way. ECU and CDI mean totally different things. Sent from my iPhone using Tapatalk
I have had a vfrness installed since 2010. I have gone through just about every stator/rr combination on my 2007 vfr800 since the originals went...
You sure they're actually two brothers headers and not just another eBay/delkavic/motad/sandy header?? Lol Sent from my iPhone using Tapatalk
I can still slap on my center stand for maintenance, I just can't drive around with it. Sent from my iPhone using Tapatalk
Plus one, if you "upgraded" the rr with some electro sport or ricks or some other non oem Chinese garbage, you could be doing a lot more bad than...
Yup good luck. It may take a few years to find one. Sent from my iPhone using Tapatalk
Ecu on a 1994? Lol I would go through every connection in the harness and look for sign of a bad connection, heat/dirt/corrosion. Mines a 2007...
15 volts is pretty high and isn't good for for the battery and can lead to a shorter life. Only go with an oem stator. I had an electrosport...
Those numbers are actually kinda high. Sounds like you're overcharging and killing the batteries. Sent from my iPhone using Tapatalk
My R1 front end, 2 bros full system ceramic coated, sato rear sets and rapid bike fuel/ignition/quick shifter controller. If I hadn't been in...
this is my daily driver so i dont have time for the bike to be down for days or weeks on end. plus i would rather let 2 bros do all the primary...
here are more specific dimensions...
Who is Ivan? Sent from my iPhone using Tapatalk
[IMG][IMG][IMG][IMG][IMG][IMG][IMG][IMG][IMG][IMG][IMG][IMG][IMG] So basically the primaries are 36mm in the straights and 39mm in the curves...
I'll post some pics in a few minutes Sent from my iPhone using Tapatalk
Lol that sums up my feelings exactly! Honestly I ran a motad header for a few years before I found a two brothers full system. The fit was...
Cheap lambda delete kit? You mean 330 ohm resistors from radio shack? It'll cost you like 99 cents. As far as the header, I had a motad catless...
Separate names with a comma.
