after working on carbs set the initial idle speed adjustment screw by backing it off until screw just stops touching, then screw 1 turn in. will...
a good motor will be between 150 and 165. engine will run ok but lack power at 120. all cylinders should be close to equal. best to partly move...
have you done a hot compression test yet ?
^^^^ this is what i shook out of a vfr muffler that spent time in an outdoor shed, not uncommon to see a few nut shells shooting out after...
in another posting you say the bike is running, right ? so obviously the coils are working fine........???? nearly all coils on hondas are...
you need to inspect for signs of "mushrooming" on the tops of the valve stems. valves are the weak point on a 500 and can destroy the engine in a...
its ez to understand ohio, basically a square. :Yo:
i test O-rings by holding carbs upsidedown and blowing air into the fuel line. spray soapy water around the tube ends and look for bubbles. >>>...
BAN THIS IDIOT
do you tend to over over-worry about things ?
it's a personal preference of course. you would need to sit on another vfr to know. my guess is that police changed bars to aid quick U-turns in...
your rotor is probably fine as the surface marks look good. measure the rotor to determine actual thickness compaAred with minimum listed in...
3 things a new 'cycle owner needs but may not think about: 1-amp battery charger multimeter volts/ohms small air compressor for tires
suggest you convert to standard vfr handlebars. mabuhi :cool:
difficult bike to ride for beginner without some practice and experience, so get some training. service manual is available online here. be sure...
THIS daft a-hole thinks it's OK to advertise cripto spam on our website......what ? :Ban:
the washers need to be fitted with the copper-colored side UP........if i remember correctly.
yes, you can do that but any VFR mods need approval by 34468 Randy. buy the man a drink.
^^ a stator in failure mode provides less voltage, never more.
you rebuilt the waterpump ?? oh goodness, that's not ez. cool trick, lad :Nod:
Separate names with a comma.
