that does the trick, impact + right-sized screw bit. :thumbs:
how utterly inconvenient. so you live in not-a-mechanicsburg ?
^^ too busy, too uncoordinated a design. :crackhead:
first, unbolt the clutch m.c. from the bar and hold it vertically by the lever while tapping the banjo bolt area. if that doesn't help.......:(...
alloy crush washers seal against leaks, determine height of needle seat. seats without the spacers means some ignorant boob worked on them. if...
quite to the contrary, i noticed the difference in noise and vibration on the first ride.
why not download a copy of the honda service manual online to answer your questions ?
with a clear tube, fuel level should be exactly where the part line is between carb and float bowl [plus or minus one mm] measured as shown. high...
the mc [brake or clutch] needs to be bled first and hold pressure before the system can be bled.
yes, the frame is conductive. if al alloy were not conductive, you'd have no wires in your bike.....now that copper is so expensive and fazed...
another possibility is a stuck-open thermostat, not at all uncommon.:confused: gauge action can be tested by BRIEFLY touching the wire going to...
david, welcome. your brake problems are exceedingly rare, so who's been working on them ??
yes, could be a lean mix so just try getting deep in there and opening up the mixture screws about one-half turn and see what happens. :cool:...
www.theshimshop.com unless you live far from civilization, try a major league hardware store
ok, so you never rode the bike.......but you think it needs a jetkit ? :rolleyes: if the finished bike runs nicely as it should, you wont gain...
so how's your bike running through the rev range, pulls strong at top end ?
a good old toothbrush and some petrol will do fine in ninety % of cases, just needs scrubbin.
it's kinda awkward getting to them, but there are two drain bolts [ten mm] on the engine just behind the front header pipes that need to be...
be sure to check the small filters above the float needle seats.
:cool: just loosen the nuts and pull the cables off the holder, the only way i do it because too many of those screws are buggered up by inept...
Separate names with a comma.
