https://www.vfrdiscussion.com/index.php?/forums/topic/84719-the-drill/ Sent from my SM-N950U using Tapatalk
A little bit of heat from a hair dryer or heat gun on low helps with install/removal. Don't pry unless you have to , then be extra careful Sent...
Competition Werkes makes one Sent from my SM-N950U using Tapatalk
Yeah, probably going to skip using Caswell for now. The soldering will hopefully be enough of a bandaid until a better replacement is found or I...
I decided to at least try soldering the pinholes. I sanded the paint down to bare metal, and used plenty of flux paste. There were about a dozen...
Well, bad news about the fuel tank. The shop I went to said he won't touch a tank that has a liner in it. Apparently there is a liner that rust...
Can do. [emoji106] Sent from my SM-N950U using Tapatalk
I have a Caswell liner set waiting. Last time I tried it, I didn't prep well enough and still had a leak. The radiator shop that brazed that...
Drained the first batch of Evaporust from the tank. It's been sitting for about a week or so. Very gross. I still strained and saved the...
Air filter solenoid valve? (Flapper)[IMG] Sent from my SM-N950U using Tapatalk
Checked on the rear cylinders valve clearances today. All are between .005 and .006... Kinda like somebody has been in there before me...
What color are the wires on the plug? Sent from my SM-N950U using Tapatalk
That's crazy! Shipping would be insane. Maybe I could fly there and pick up for cheaper [emoji1787] Sent from my SM-N950U using Tapatalk
Wow! [emoji7] I couldn't find any tanks when I looked, but I did not look international.. shipping would be insane, but probably cheaper than the...
Got the rest of the fuel strainer out of the tank today. Like pulling a quarter deep out of a hole that's opening is slightly smaller than the...
Don't forget to drain your puke tank! [emoji2961] The Air Breather Box that the crankcase vapors go into.. not the coolant overflow That's some...
Looking for the heat shield for the carb rack and the rubber piece that mounts with the back part of the fuel tank. I have an 86 frame, but am...
It was a little warm today, so I took her in the driveway to clean some of the dirt and crap off her. I used the "scrubbing bubbles" spray....
I removed the carb rack today to replace the 38 idle jets for the 40s as recommended. Seems to run pretty well. Thanks for the suggestion Captain...
Got the sync screw tool from Honda. It has a little whoop de doo at the end and is a 7mm hex driver with an internal cable attached to the...
Separate names with a comma.
