Rode with the new tire today. Didn't notice the vibration, but I was on a rough road. Still battling the high idle when coming to a stop. When I...
Still looking for advice on the high idle problem after riding for a while. Recently noticed a vibration. Can't seem to pinpoint the location....
Rode it a little today. Seemed to run better than it has been. But a previous problem started again- when I come to a stop, it idles around 3000...
Recently I haven't pulled the carbs. I did when I got it about two months ago. I pulled them out, cleaned bowls, jets, passages. I know I didn't...
A lean condition doesn't sound bad? I just want to figure out why they look lean all of a sudden. I don't recall the old ones looking anything...
I took three out of the four spark plugs out a few minutes ago to take a look. (LF, RF, RR) The ground electrode looks lean on all of them to me....
I put that shrink tubing on today. Still leaks. Apparently my seal is damaged too much, but I think another layer of this stuff would help. I just...
I don't think I'm going to attempt to replace the seal unless the leak gets bad. Invisible cities, I just purchased that shrink tubing but I...
Well I just have some shrink tubing on the rod now. It leaks about a half dollar sized spot of oil after riding. I have some other shrink tubing I...
invisible cities: Correct. I have removed the vacuum petcock system and have "gravity feed" to the fuel pump. I understand true gravity feed is...
Call me an idiot, but there wasn't enough gas in the tank. I didn't think that was the issue since the fuel flow stopped when I had it on RES, but...
I tried taking the fuel pump out last night, and it seemed to run fine, but I was letting it warm up this morning and it died and wouldn't start...
Well it hasn't actually died while I was riding (except one time last week when I came to a stop). I pulled it in the garage today after my ride...
Well shrink tubing doesn't seem to help much. My dad and I are going to try to get a new seal in without splitting the case as soon as we can get...
It is the pushrod. I've been looking around on the internet and have found that you are "supposed to" split the case the correctly replace the...
Hopefully I can take a look at the fuel pump tomorrow or Sunday. Thanks for the help. It looks like the oil seal is available, but it doesn't look...
That does sound very similar to what happens to me. It has died on me twice during the 30 miles I have put on it. Once while I was downshifting...
I made sure fuel was coming out of the fuel pump, and it "looked" sufficient to me, but I have no way to measure if it is. I basically rode it for...
They don't look fouled. It seems like the cylinders get warm in order. (1, 2, 3, 4) The left rear cylinder gets warm first, which happens to...
I finished my MSF course this weekend and I'm hoping to get some riding in this week. It seems like when I start the bike (with the choke on ), it...
Separate names with a comma.