I'm using a facet 40171 solid-state pump w/ inline fuel filter on 87 vfr700. The pump has built-in shutoff. Not using pressure regulator, ran out...
If your rear disc has grooves, ie) visible channel worn on one side of the disc, the caliper slider pin squirelman mentions has seized.
My first attempt at use a facet pump failed due lack of "positive off...a full tank of gas would flood the carbs when the ignition was off. Last...
If you do go with the 02 sensors, I would love to hear more about it. I'm considering the same but not sure where to locate the bungs. It would...
I believe the 2nd gens were assembled at the goldwing plant in Marysville, OH. Interesting if any goldwins had the same markings (my 2nd gen does...
Anyone have any good experience buying custom decals online ? I'm looking to make VFR version of a Goldwing decal.
BTDT, My old suzuki (mikuni), you turn out the sync screw to increase idle. The v4 carbs are the opposite, turn in the screw to increase idle....
+1 for bleeding the banjo bolt. That did the job. A helpful tip from this post...
I had a leaky clutch slave clylinder (service manual calls it release cylinder). I cleaned & replaced the seals in the master & slave cyls. I...
Can you provide some specs on your scooter overflow tank ? So far I haven't seen anything that would replace the vf750 tank ?
Need replacement middle stays for the vfr700 lower fairing. The originals were pretty wimpy so I would like to find something stronger, anybody...
I'm interested in the F2 hand grips. Do you have any photos?
great photos. I have similar problems mounting one of Jamie's shock on my 2nd gen vfr700. I was thinking of using a 90degree elbow on the upper...
Anybody actually bought something from Carnage Moto (based in France) ?
2nd Gen in Hamden. PS Looking for someone todo plastic repair ...
Pulled the keihin CV carbs from my 86 vfr700. I want to remove the jet needle from the diaphram/piston assembly. The needle is held in by a...
Good advice but will cause a cloud of oil smoke when you start your bike next season. Or maybe I add too much oil.
Thanks squirrel. I noticed the float valves have an internal spring, last carb cleaning I had a spring stuck, it took some persuasion to...
Pulled the carbs from my 86vfr700, now sitting on my worktable. Everything looks pretty clean, no leaky o-rings or torn rubber diaphrams. Bike...
I replaced the thermostat and rad cap. I refilled coolant at the radiator. I confirmed the thermostat is opening. Now the overflow reservoir...
Separate names with a comma.
