Good thing it's too far away... Sent from my moto g stylus (2021) using Tapatalk
Ok thank you for that! Sent from my moto g stylus (2021) using Tapatalk
Forgot to ask: the rebuild kit came with shims for the float valve seat. When I took it apart the first time, there were none under the seat....
I figured it was a bit high. Thanks for the input. I think I'm almost there. I checked the front plugs and they looked lean, from color. I...
Thanks Squirrelman, I appreciate the input. I figgered it was a bit high.
Ok, back at it again. New floats all around, adjusted those, cleaned what I could, again. It starts like a champ, I can run around the...
I took the carbs off again and found three interesting things: Carb 2 definitely had no fuel. Its float needle had fallen off the tang of the...
Today was a bad VF Day. I need a hug...I ran the engine some more and it seems it is making progress, kind of. Whether choke or not it doesn't...
....true
Ok thanks Cap'n. After doing this , and if it doesn't reveal anything, I'll take the carbs off and check the pilot jets. They are new, but...
Hello, welcome. So, that's what it's supposed to look like...
The air box is all on as it should be. The carb boots are all new. You thinking air leak? I know I have zero clearance on cyl. 3 and the boot is...
Hi, the best run is with full choke. If I let it run for a while and warm up it gets to about the same point. I will pull and inspect the plugs...
Sigh...All back together after checking everything and making sure the diaphragms are seated. Same issue. It starts great, the slow circuit is...
Ok thank you! It's possible they weren't seated right. I know I did not install them ax you described.
So, I've removed all of the assemblies and what I found: All the needles appear to be the same. I do not think these were included in the rebuild...
Thank you, I was wondering about that too. I also read (but can't find anymore) that the fours have two plunger needle sizes, two for the front,...
Hi All, I hope yoh can see the video. I finally got around to working on the 700 Interceptor Its carbs have been cleaned, new jets, etc. It...
Thanks for that info. Checking the valve clearance is the first thing I did. Tight they were, but not horrible. I am used to Yamahas and Kawasaki...
Thanks Cap'n. I was using the edge seams as a reference. I think my staples are from HF, as the gun itself was purchased there. So the crotch...
Separate names with a comma.
