You will need to pull the tail plastic, but look at the connectors coming off the voltage regulator if you haven't. Especially the one carrying...
It could be a bad battery. I had a similar battery failure recently where trying to start it caused an instrument panel reset, but I was able to...
If that were my VFR I would be pulling that out of there and unwrapping the yellow tape to see what was done to the wiring. That seems to be a...
I'm not too sure on 6th gen modifications, but hurricane offers two different Police kits for them. 06/07 with ABS, and a kit for 02-05 without...
The fact you had to add fluid would have me concerned. That shouldn't need topping off. If there's no obvious leaks up at the handlebar, I would...
I never noticed, as I've used a Clymer manual for this job.. but you're correct. I reshuffled the photos around to match up with the steps....
Well, since the camshaft gear drive is so loud... my choice would be "Gear driven cams save lives"
The website seems to have cut down on the image sizes for the colorized versions I just posted, they're much bigger on my end. I've put them in...
I should post these here as well, I colorized the camshaft gear drive. The images here aren't the full size ones, as the website has reduced...
If you like engine cutaways, I vectorized the 5th gen engine cutaway illustration from the service manual....
I'm glad the install went smoothly. Being able to relax comfortably while that engine sings its song is nirvana. I've done 1,000 mile days with...
You're right, ignition switch doesn't matter for this since it's before the fuse.
For something as important as sprocket hardware, I'd go with Honda OEM parts. If this is a fifth gen, those part numbers can be found on the Rear...
Instead of sacrificing fuses, you could try a multimeter. Disconnect the battery for safety and pull the offending fuse. Set the meter to a...
Is this a Fifth gen? Wait until your new chain and nuts get in before playing with it. Remove the old chain to get it out of the way. Captain...
Those cap screw bolts are torqued to 14-15 ft-lbs and should have a medium thread locker applied which is why they're such a pain to remove. I...
Honda actually left this little bulb in the Dullville when they brought it to North America in 2010. It was such a half-hearted release for that...
Those covers below the headlight are all black, they aren't paint matched. They are a vestigial feature on North American VFR800Fi, but are there...
That loud noise is the gear train driving the camshafts. It's on the right side of the crankcase so it's louder than previous generations of the...
In the service manual, go to 19.19. perform the tests as outlined. The following is getting ahead of the tests you need to run, but the fuel...
Separate names with a comma.
