I am waiting for him to engineer a set for my 8th gen. The Quick Shifter changes everything.
Contact Larry Lovisone, in Sacramento CA, he makes a nicely machined set, for about $90.00: netters2@comcast.net [IMG] Peg is from eBay.
Well we all hoped it was in the top end, good luck with your new project!
With a bike of that age, inspect and clean all connectors, battery terminals and ground points. Look for corrosion which pass voltage, but not...
Your right, I watched the videos on their website, not exactly made for the twisties.
At least you have narrowed it down to the rear cylinder! Keep us posted.
I am trying to figure out where the steering/wheel pivots!
Not sure, but I think i am going by intensity. If you have some plastic/vinyl tubing kicking around, try that as stethoscope.
Listening to it again, and it may an exhaust leak, maybe gasket wasn't seated correctly, it would be great if that is all it is!
Plus you don't have to take out the Honda weights out of your stock bars.
Check out www.vibranator.com, I used these on my '03 with helibars, worked great. At least read info on how to dampen vibrations.
If it was the needle float valve, then gas would be coming out of overflow hole. My tip was meant to be done on the bike. I think once o-ring...
Could be an O-ring, if you can get to fuel line by the carbs and slip it off, try running some lacquer thinner through the carb for about an 1/2...
Mine was oil, not gravel on the Angeles Forest Crest in '85. Someone had blown an engine or bad oil leak and center of road was black with oil,...
I would get one of those cheap stethoscopes at AutoZone and try and pin point it to which cylinder. Might be a sticky valve.
Went for a ride out through the twisties to Peets Coffee and back. Seahawks & Patriots, ought to be a great game.
Had old ford van that developed a bad main bearing, didn't sound anything like that. Sound is too sharp, high pitched for a connecting rod...
I would leave the air box and snorkel alone. Comments have been negative from everyone who has tried. Only thing it does is degrade performance...
I found that the Power Commander fixed the low RPM roughness, had same problems with my '03 when I got it. Everybody on the forum recommended the...
Thanks again, found the knob and adjusted idle. It was getting hot at long lights out here in CA. On my 03, it was on the right side. PS: Went...
Separate names with a comma.
