The horn/turn signal button swap is really a nightmare. When your hands are on the grips, the horn button should be where your thumb normally...
I checked my 2003 manual, but no info, just google VFR800 Center stand removal, comments I saw said you had to, but recommended getting gaskets first.
Yes, about $90 a set. Just email Larry. Will require adjusting shifter and rear brake (a PIA, but worth it)
[IMG] A simple burnishing of the contacts should be OK for awhile. I used an emory board, peel off the rough side and trim to fit female...
I saw the picture of the stator & R/R, good idea if you have room, better yet, remove right side panel and inspect stator wires & connector and...
Those are from Larry Lovisone - Busy Little Shop in Sacramento, CA, I had them on my 2003. netters2@comcast.net [IMG]
Thinking out side the box doesn't always mean better, somethings are so ingrained it makes it difficult to retrain ourselves. I find I have to...
I'm half way to 72, and I still have my original VF750 and a red deluxe. Don't need two bikes either but can't part the old girl. I did part with...
When I had my 6th gen, heat was a problem, especially at long CA traffic lights. I installed manual over ride on fan to keep it in check. No...
Not spam at all, we crave new information and processes. I think everybody just assumes glass bead or sand blasting is the way to go. I had no...
Wish I knew about his service last year before I had my fork sliders powder coated, they got glass beads down inside which got trapped in the oil...
Carbs and aluminum plate come off as a unit, do not separate carbs from plate. After disconnecting choke and throttle cable, loosen ALL the bands...
Answer to your riddle, there is no "off" hole, you have normal "On" pipe hole (which picks up gas to a higher level), a "Reserve" pipe hole (which...
Found some good pictures, be careful pushing wires through, could damage screens: [IMG][IMG]
I wouldn't power wash the bike, at best use plain water only at a distance. High pressure soap will be driven into places you never find. A...
Inside your tank are two convoluted pipes that feed the fuel tap that could be clogged. I have drained gas by gravity and it should be more than a...
I have put just under 10K miles on mine and can't think of another bike I would rather have. A lot of guys on here are always looking for more...
Don't think so, engines look to be at totally different angles, front two cylinders are almost horizontal on the sabre/magna engine.
I don't know about your year, but I needed an assortment of extensions and swivel adapters to get a good angle on the rear nuts on my '83....
The exhaust gaskets are designed to crush and conform to the angles between the headers and the heads. If the headers have been rattling around,...
Separate names with a comma.
