Yeah, you don't want that. The front needs to be as sticky or stickier than the rear. If not.. hello mr. high side.
Personally I think there's alot of over hype regarding mixing tires. I'm running a bias rear POS on one of my bikes and I believe the front is a...
Get a crossplane R1. Sounds like a VFR.
The 1986 750 was officially released here, but thanks to Harley's whining and the tariff tax that followed Honda also released the 700 as a tax...
Probably your reg/rec. The key to the stator check is to do the AC output reading. I had one go bad that ohm'd out within tolerance.
I don't wear any heated gear, but have found the following layer setup to be suitable for any cold weather out here. Base layer is polypros...
Noise regulations? If your bike is that loud, somethings wrong with the top end.
No worries man, I've dropped my CB-1 a few times. I even managed to snap off a rear set without dropping it. So lessons learned I've starting...
I've got that Kerker setup on mine, sounds sweet. Hard to capture the sound of exhaust through video, but at lower revs has a nice V8 sound to...
Yeah, at least on the older vfr's the clutch push rod penetrates the crankcase via an oil seal and interacts with the slave cylinder in an...
No idea but have a few questions. Was the bike running before you played with the carbs? Did you let the bike warm up fully after seeing this...
First of all, I wasn't talking about the Integra automobile. I was talking about the NC700D, which is a scooter....
I've still come to the conclusion that it's a scooter dressed up as a motorcycle, and there's scooters with better storage. The powerplant was...
Could be a break internal in a wire leading to the switch, check around any pinch points and try flexing the wiring while power on
There was a fairly annoying HD incident over the summer. On a group ride we got stuck behind a herd of hogs probably 25 deep going 15 under. So...
Solder joint may have loosened up. Or decent amount of oxidation on contact surfaces.
You guys use the kill switch to shut down the bike? I leave the kill switch on all the time unless in an emergency (what it's for) key off only....
Duct tape and gorilla glue Also, if you're expecting a jb weld price point with Belzona... well let's just say you get what you pay for. The...
I haven't had a reason to order the stuff for a few years now, but I punched in a PDX zip code with no results. I would wait until Monday and...
Your best bet would be to contact them directly and find a local distributor if possible. Prep work mostly involves getting the bonding surfaces...
Separate names with a comma.
