Big Thanks that just what I needed.
It's a crap shoot for sure. Stock jetting just may be fine. you may just need to raise the needs. You need to find very small washers that will...
Nice job all around. I like the way you used the fabric as a molding base. Nice trick! Nice paint also.
My 83 just had a tail light sensor go flaky. I jumped around the problem for now. I bought a 84 sensor a while back thinking I'd have a spare....
WHAT! The finger?? You sick old bastard
Oh I thought he said "drag". Yea it could be a Scotsman............................never mind old time moment.......
If he fried the clutch then DO NOT put it back together without new steel plates. If they're warp .012" or more the clutch will slip. You won't be...
You know your getting old when your day starts with reading "RANDY" posts...............................................like the obits
It could have sucked enough oil mist in to the pipes and set for a while making a collection of fuel/oil mix that created the smoke. Then like you...
I'm assuming the bike has a catch container (over flow) where the engine breather tube (vent) goes into. It will fill with any oil blow by instead...
pics when your done.
bad plugs, low output from ignition, plug wire, burnt valve or popcorn in the pipes.......................................
Pilot circuit in the carbs are dirty/blocked. You should have dumped that gas. Check your tank for rust, check for a possible plugged fuel filter...
Is it the motor or is the over flow tank full and sucking in oil crap?
Meant to say 60', I was looking at the slow reaction time when I typed it. Thought about it later and went daaa. Can you come off the line harder?...
Thanks for the words. I knew this was a winter project when I started. I figured it would take some time to do. Like any new project of McGyvering...
Sorry to hear about your accident. Take care of that hand/wrist first and foremost. I've busted my right wrist up and have been feeling it for...
*Finished* Well I went to the body shop the other day to ask my friend what type of primer to use for the black or dark gray. He just finished...
No it's thinner than that and when it dries on the outside you can rub it off like a hard power. The bottle says R6K. Your guess???
Good job that's no slouch of a time. Get your reaction time down to something decent and you'll be solid 10.80's.
Separate names with a comma.
