Try using a heatgun to soften the glue holding them together and then scrape the glue out and gently pry apart.
Aren't the mufflers painted steel?
It looks like these RC26's have unusually short shocks and that's why it's hard to find replacements. 270mm eye to eye on the '86 model.
I thought it was obvious, I have the stock shock in there. There are no adjustments at all except preload and I tried out all it's range. I...
Will that make it ride smoother?
I sent him an email.
Are you talking about the preload? I've tried it at all the adjustments. Full firm gets rid of the small undulations I feel, but bounces me...
Are you saying the hurricane shock was too short? It should be easy to make it longer if you can cut and weld metal. Now if it were too long,...
I'm pretty sure a 220lb person would get bounced up as well. Any other ideas? I've looked at Daugherty Motorsports, but they don't show a...
Nope, it's a different unit and has no air assist. It only has the hydraulic preload adjuster. The springrate seems fine. I can compress it with...
OEM says 32psi front, 42psi in back. I dropped it to 35psi and it helped, but I don't know if lowering it any more would be safe.
I'm 180lbs and any time I hit a bump in the road I'm bounced off the seat. Adjusting the rear preload to full soft reduces how high I'm bounced,...
Check the wires in the right hand switch. Your kill switch or starter wire might be shorted in there. The same wires could also be shorted...
Yes, they might be related or it might just be a coincidence.
I'm putting zero money into this. I've already ridden over a 1,000 miles as is so it's not that big a deal. I might pull the pilot screw all...
I played around with the pilot screw. I turned it all the way in, then out to 4 turns with no change in the engine. It's got to be blocked,...
I don't see how that is possible. Are you thinking this brass piece is leaking air around the edges and this is why this cylinder misses at idle?
I was thinking of adding a short length of braided steel line. Crimp a loop in one end and clamp it under that bolt near by and put the other end...
I fixed it up and it runs great, just kinda uneven at idle. Maybe I should apply some JB Weld all around the edges to make sure it's not...
Can anyone tell me what this brass part is? As you can see, when I bought the bike one was missing and the aluminum damaged. How it happened?...
Separate names with a comma.
