You can get some mikuni flatside carbs - only about $3000...
If the jets are getting clogged again, what's the condition of your tank/fuel filter? I bet trash/rust from the tank is getting past your fuel...
That's great! I'll take some measurements too. The only aspect that cannot be worked out is the angle of the mount. I'll measure my mount angle...
I've got the "old" style rubber footpegs and am looking to change them out to newer looking ones like on the '86 and up VFR. Has anyone every...
As was said before, use a piece of copper wire from a multistrand cable. The copper is softer than the brass and will not enlarge the jet holes.
On the bottom of the ignition switch are copper contacts. Sometimes they get dirty, corrode, get hot - all conditions that inhibit good...
Wiggle the key, sometimes the ignition connections get dirty.
On the '83, the front and rear carb tubes vent to the airbox. On the 84-85 those front and rear carb tubes are tied together under the airbox...
Read this site for alot of info: http://www.roadsafety.mccofnsw.org.au/a/88.html "a single layer of 1.4 mm cow hide will last 5.8 seconds,...
I believe the 84-85 VF700F's have a different advance curve to make up for the loss in displacement. They should work for your '83 VF750F, just...
I've got an oil leak on the shift shaft oil seal behind the neutral switch. It's the parallelogram looking cover behind the crankcase pressure...
Closest one I've found is here: http://www.honda-v4.com/sabmag/vf1000f.html
Test the sensor when the bike is hot. Heat can cause an electrical component to show as failed, but show as good when cold. Sounds like a fuel...
Starting solenoid could be bad. Replace any connectors/wires that are/look burnt.
Does it happen when the bike is cold, or hot? If only when the bike is hot, the return hole in the MC is gunked up (under the silver tab at the...
Since the bar ends on my bike are non-removeable, I've entertained the idea of mounting these:...
If the lever is mushy, you either have the brake lines expanding, or still have air in the line. Have you burped each banjo bolt - working from...
Run the front or both tires onto a 2X4. I worked on a Virago that no matter what I did, could not get it onto the center stand. Running the bike...
You can get sea-foam at most auto-parts shops. It reduces carbon and gas varnish. Typical treatment is to use 1/2 to an entire can of the "motor...
If you have brake fluid leaks down there, then your slave cylinder is probably leaking. Get it fixed pronto - it can corrode the slave cylinder's...
Separate names with a comma.
