There are various version of these, Titan Bulldog Moto Cradle Wheel Chock - webBikeWorld ,two mounted to a good plank or treadplate could be...
You can use Suzuki SV650 bars which are also 41mm, or do what I did & file the offending protrusions down to allow the angle you want. You can see...
Nice pics & the bike looks good too :cool:
Well got a little work done a couple of weekends ago & just got round to writing this. Poor pic below, not finished the install yet, but had a...
yeah well I was having a brain out moment, yesterday & checked what I'd installed in mine lastnight :smile:
Why not just use a bike trailer if you already have a tow hitch & a truck to dump the trailer in ? A friend of mine advised that if you ever get...
Oh forgot to mention that NGK CR9EHIX-9 is what I use in my 5th Gen, so its fine the heads are the same !
Yep spot on, the crush washer is the reason for the 1/8 & most will give you 4 tightening a before that washer is fully crushed ! :smile:
Well the standard way to fit new plugs is hand tight plus 1/8 turn with spanner/socket !
Maybe that did not come over correctly. The centre of the frame pivot on the VFR swingarm is NOT the wheeel centre line. The wheel offset is how...
I think you might need to rethink your adjustment method. The wheel is NOT central to the swingarm bearings ! The left side is critical for chain...
According to this NGK decode page NGK sparkplug symbol code decode it should be fine, all important dimensions are correct. An Iridium tipped...
Sweet I like the look of those & they save having a cable exiting your grips ! Excellent idea & having used snowmobile heated grips on a trip to...
If you have trouble, use some penetrating oil (not WD40) arround the oil seal in the slider. Then put a thick bar through the axle hole in the...
Sweet front end, I'm sure its just the angle of the pic, but the forks look bent. Is that a true straight bolt on replacedment ? no special...
Is that all the DR650 makes ? My DRZ400SM was doing better than that, after a few mods :biggrin:
So did you get a video made & is it still working as expected ? I'm rigging up a handlebar button based on this info :) Thanks for the heads up.
If this mis 5th Gen, then the lower is NOT difficult to remove, you just have to note where everything goes. Get some colour tape & use it to...
Well having read about MD's front end conversion & having improved all other areas of my Viffer over the last couple of years & having attended a...
Not me, Pete at Ti64 did. All fitted perfectly, all done now.
Separate names with a comma.
