Restless women getting into trouble
rear brake over haul after 30 years.
close up
The Fairy landed on the Interceptor before Halloween.
how about a carburetored Kawasaki Concours? just throwing that out there. Most STs out there are FI bikes, first gen ones went to FI when?
WOW! What a blast from the past, I remember the old Radian back when I had my Kawasaki ZL600, what a pita. Remember the Fazer had some funky gold...
I have not replaced any of my wheel bearings on any of my street bikes eva, I don't ride through creek crossings or use power washers either. I...
nice bike, you should look into a Pyramid chain guard/hugger.
I lowered my fork tubes like this. One bike has a full race tech gold valve set up in it, the other just has some traxxion dynamics fork springs...
Looks good, I have my gear shifters up one notch I think. There is a dot stamped on the shaft as well gear shift lever. Its all subjective though...
The needles have stock washers from factory. I wouldn't drill any of the slides of any of my personal bikes. Consider getting the factory manual...
Terrific! Now you can travel to Key West on it!
What a nasty looking "slave" totally grundge-ah-fied. :mech:
I have gen3 bikes, same as your gen4 bike for all intents and purposes. You are dealing with 24 year old rubber o-rings and hoses bear in mind. My...
Someone who should not have been working on motorcycles or any internal combustion engine was obviously turning a ratchet to tighten that spark...
You should consider getting rid of the roached out bleeder valves, I never had problems with my brake calipers until I rebuilt my 91 front...
Hey!!! Nice write up!!! I went through all that stuff times II, its kind of par for the course when your working with 30 year old motorcycles. I...
rear wheel should have zero side to side play, from what I heard the bearing set-up is pretty much bullet proof. If you have to remove it, it...
nice work! does it make you long for carburetors (not being a wise guy - valid question.) Peace
Separate names with a comma.
