Never mind, figured it out. The labeling originally on the back confused me and I got the ground and power wire switched.
I've deleted the tach and modified the cluster housing. Tested the fuel and temp gauge, finding the fuel gauge is giving me issues. Fuel tank...
Past week or two, rewired the fuse box, deleted the tail/stop sensor and replaced fuel pump relay with a jumper wire. Buffed out the mufflers and...
Starting to make progress again =D Got the brakes and clutch working properly. Battery was draining when I let the bike set for a few nights...
Was in the process of doing just that. Brakes firmed right up, thanks. Going to get some bleeder banjo bolts so this doesn't happen again.
Only one of the brakes worked so I rebuilt all of them. I think there's an air bubble in the banjo bolt, due to the Magna master cylinder...
Bike has been sitting without the front bolt hole mounts aligned for months. Is it safe to remove the rear head dowel/bolt permanently to get the...
It's been a while due to having to buy & rebuild my engine in my project car. Was hoping to have this bike sold this summer, but there's always...
Project is not dead/forgotten. Car needed a replacement engine and it's been eating my time ever since. Will post, and repost, pictures soon.
Not much on the early tanks so I'm making a thread to address it. Been trying to clean out a tank for a while now but the last patch of rust i...
Tested both tanks [good and bad] both don't seal all the way, so I guess that's how they came. Was hoping to line the tanks but can't get the...
Could anyone check their tank? Takes a minute. -Open cap -Wipe the sealing surfaces -Use a highlighter to color tank surface -Seal/lock cap and...
Does the VF700/750 gas cap completely seal or is it open for venting purposes?
Rewiring/wrapping electrics done. Working on making temp gauge. [IMG] Exhaust is wrapped and ready for protective paint. Only had 25' and...
Had to order a new set of fuel tubes off eBay. Got the carbs back on and wired in controls, waiting to wire in tach till engine is tuned. It's...
Had to take the carbs off a week back to get at coolant lines and managed to break all the fuel tubes =( Hope to have the pressure test...
Went to the swap meet today, not much for parts shopping. Managed to at least find a left & right control switch and some general items....
Thanks, but I am holding off on looking for replacement parts till after i goto an upcoming swap meet in the area.
...and confirm running. Probably need to adjust idle all around but the project continues.
Putting the bike together to do a run test, looks great. Can't get the front left side bolt in, but I expect once the frame gets on wheels it...
Separate names with a comma.
