For first generation: 500cc bikes have 37mm forks 700-750cc bikes have 39mm forks 1000-1100cc bikes have 41mm forks
Unless you separate the carbs, dunk them in carb cleaner and blow out the passages with compressed air, It's most likely you're not going to get...
I believe the "R" has gear driven cams, while the "F" has cam chains and tensioners.
Tim Cameron of VRex fame, transplanted a VF1000R motor into his bike. But with the VF1000R, you have to drop the engine slightly to get the rear...
Per the Dennis Kirk website, these bikes use the same front rotors as your bike: # 1983 Honda CB1100F # 1983 Honda CB650SC Nighthawk # 1984 Honda...
The pump will only pump until the pressure reaches about 3 psi. The pump cannot overcome that pressure and stops. As the carbs use the fuel, the...
To test for a leaking carb boot, spray WD-40 around the carb boot when it is idling. If the idle changes, you've found your leak. Do all 4, you...
The steps I gave you are general methods of determining if your bearings are loose or need to be replaced. Here is another website that might...
Site Glass Replacement Over many years, the OEM site glass can get cloudy, soft and may unnoticeably start leaking. The solution is to replace...
The stock rear sprocket has 43 teeth. The stock front sprocket has 15 teeth. The stock chain length is 108 links (530 chain) Top speed is 128 mph
Put the bike on the centerstand and prop the front wheel off the ground. Pull up and down on the forks. - There should not be any "clicking"...
Probably not the oil pressure. Probably just the sound of the cam chains (it will sound like a whirring noise). The tensioners can wear and not...
No, a 750 motor will not fit in a 500 frame.
Do a Fuel Pump Flow test. You may not be getting enough fuel at high RPMs. Also read these as they may help Carburetors/Tuning - SabMagFAQ
It's the return port in the bottom of the master cylinder. Take fine tip needle and carefully clean. As the brake fluid heats up, it expands and...
I believe, but I'm not sure that the tubes with the nipples on them you refer to were originally routed into the metal air plenum. But in later...
Site glass replacement - SabMagFAQ BTDT - actually I wrote it...and have contacts if you just need two...
I'm confused. Not really sure of what you are trying to say. The carbs are numbered according to the cylinders they mount to As sitting on the...
To test if your choke is closing enough, push in on the brass choke valve. If it goes in at all, then the choke cable is too tight, the linkage...
Separate names with a comma.
