Cool stuff here......... https://www.poppystore.ca/
I'd suggest making a permanent food intake change, as if you were diagnosed diabetic or Type2 diabetic. Forced change if that happens to you.......
[ATTACH]
As much as we dislike politicians, doesn't matter who's in there, you can't please everybody. It's been going on long before the current...
I read this and thought you found your hub......... yes or no? On Partzilla, I see the nut, washer and dampers showing as available. What are you...
If it were me, while the axle nut is off, time to dissassemble the entire rear end, check bearings and give them a good greasing before putting it...
The PO may have had the final drive apart and perhaps didn't torque properly and stake the nut.... the hub shouldn't be too far from where you...
You lost the whole hub and everything? Rear axle nut came loose somehow... wasn't staked?? Yep f-ing lucky in a few ways... Your hub and...
Worked on an '86 about 4 years ago while visiting a buddy... had a miss at idle.... not enough time to dig in deeper, but we got it running...
Get the cereal with Tony the Tiger on it... bike will go faster.....
Ha, in a pinch, make a gasket from a cereal box, coat in grease and install. However, RTV is available at your local auto supply........
The rear brake is probably more effective than you think.... in a panic stop, it will likely work fine. Most say their rear brakes are a little...
I haven't done this, but perhaps others more experienced with them can comment...... do the starter valves need cleaning? Readjust #1 slightly...
Have a read here if you haven't seen it before............
Where do you live? If the temps drop below ~40F, they may not crank, and need to be warmed up with a charger or by leaving the headlights on for...
My Magna was in rough shape when I got it, rusty exhaust, aluminum pitted, etc. It was never going to be a full restoration project, but I did as...
[MEDIA]
Nice looking for sure, but I'm over my '83 V65 Magna days.... I could only go if I could borrow that bike magnet truck of yours, lol.
When I first got my '99, it had an older TwoBrothers.... too obnoxious, but the pic gives an idea of the position. A friend had also bought a...
When on a trailer or truck, need to keep the front wheel in place.... I use Harbor Freight wheel chocks that have a tie-down point on each side,...
Separate names with a comma.
