I'm guessing you're trying to slide the tube off the bar without undoing the cables... can only be done if you remove the handlebar, drop the fork...
https://www.cycleworld.com/story/motorcycle-news/honda-hawk-11-revealed-japan/
I got mine used from a forum member...... http://convertibars.3dcartstores.com/ConvertiBARS--Original_c_8.html
If you know the hole to hole distance, you can make your own dogbone links.....
If you're going to keep that R/R, I highly recommend you install a voltmeter to monitor charging voltage. If anomaly's appear, you'll know it's...
No experience with the 1200's drive shaft, only pointing you in a possibility...... the driveshaft has a damper portion, may be slipping under...
I have a set on mine... essentially, Helibars would do but the convertibars give you some additional lift and ability to tweak the handlebars to...
I put a Galfer kit on last year, I believe 11 lines total.... give the seller a call and see if they'll delete the rears? Buy the kit and sell...
Agree. A couple of failures of an adjustable link on the Versys 1000 forum as well. With single links, I would hesitate to go this way and...
Hope this helps, I got some replacement turn signal lenses from China.... the sonic welds do not hold up for very long..... suggest you remove and...
I gotta stop hanging out here, it's getting contagious, lol. My propane tube heater quit working yesterday.... luckily all I had to do was...
The ones he recommended are the best IMHO..... another problem with the other ones in the video is that the band is far too wide. Narrower ones...
That may not have been the final picture, I tweaked clamp positions as I went... I put them where stuff wouldn't snag from contact with anything...
Got a booklet from Renadian Adventure Tours yesterday, excorted tours of Africa, etc. and one to Ushuaia, Chile. Fly to Mendoza, Argentina, then...
Gee, the 1200's wheels already look great, I would spend the money on suspension and tires too, probably cheaper in fact than carbon wheels.
Stray, find the stainless rod that is the flame detector rod ..... take it out and clean it with some Scotchbrite to take any surface...
If the wiring is OK, check the condition of the wheel sensors for corrosion also......
The nut usually has provision for safety wire if your fave track requires it.
I'm with Grum, I'd kinda start all over and check all the hoses. As for starter valve sync, follow this direction for a proper sync. Makes a...
No I just borrowed part of his name...... I've met Steve a few times, still don't have his autograph, shaking his hand is good enough.
Separate names with a comma.
