New mosfet r/r fitted and job done on orange block, no problems anymore, for now! Thanks all for suggestions etc
Ok. Drill results. Leakage test 1mA Battery output rest 12.6v idle 14.3v and 5000rpm 14.3v Alternator at pins connecting to regulator showed no...
Just to follow up.. only got to take bike out over last couple days and absolutely NO Fi light weirdness.. at least I know where to look and what...
done job on it Well. This is not work I am proud of. It is my first bit of electrical work so I can't be too hard on myself but I have a feeling...
Cheers. I can only wish mine will look anything as good as your work! I don't think it original rr I think it's a 6th gen one wired in. The rr...
http://www.vfrdiscussion.com/forum/index.php/topic/66045-urethra-i-found-it/page-6 Doing a job on mine shortly to hopefully fix Fi light problem....
http://www.vfrdiscussion.com/forum/index.php/topic/72307-fi-light-flickering-on/ Bit of reading
Pic of the test block. Seems in very good condition. It has twelve orange wires. I don't know if I should leave it or look into removing it Okay...
Ok. I'm going to go in detail here and hopefully mellow dude might have some ideas for me. 98 fiw, 25000 miles on her. Owned and rode under a...
http://www.bikersoracle.com/vfr/forum/showthread.php?t=76159 Good post here
I think it may be a 6th gen rr mod like below? http://www.bikersoracle.com/vfr/forum/showthread.php?t=48680
Picture's
Well.. The new mosfet regulator came on Monday and I got it onto the bike and she fired up.. drove it on Tuesday about 40 and just got a chance...
Iv just re-read that full sticky post again, the only thing im lost on is what is the point of joing the wires if its still a thin guage wire...
Plisken I just looked at that post again and I carried out the multimeter text on the stator wires while the bike was running, it showed up 15/16v...
I have same bike, same problems, no wiser yet, Im waiting on mosfit r/r to arrive, in the meantime im trying to figure out how to do a bulb text...
hopefully will do the same here, which wires did you change the 12/14 ga wire for a 10ga from the stator (or is that even possible i think the...
its at 11.6 v still with high beams, thats after a few days without a decent charge though and i was running it for a minute without stator hooked...
Ok just so I'm straight... Iv checked 3 wires as shown while bike is OFF. Set at 20 ohm it read 0.01 for a few seconds on each one before...
Just ordered new regulator ............ SHINDENGEN-MOSFET-FH020AA-REGULATOR-RECTIFIER-KIT-REPLACES-FH012AA Thanks to the ECB printing money it...
Separate names with a comma.
