I set the mixture screw now at 1 and 1/2 turns but it starts always at 3.000 rpm (without choke): any suggestions?
If it can help to diagnose, I started it with full throttle, and when it started it made a big bang from the mufflers. Maybe the engine was just...
I really don’t know, actually…maybe cleaned better, and give more throttle during starting attempt, nothing more new. Now I’m going to set this...
It’s alive!! Finally! Now the problem is that the idle is at 3k, do I have to tight a bit the mixture screw?
My guess now would be maybe some air leaking somewhere, gonna screw tight the intake mainfolds.
Yes, checked and cleaned all the four of them yesterday: spark is present.
Idle circuit is perfect, spray comes out flawlessly from both the little holes in the throttle valve housing and from the mixture screw housing…...
ok sixdog, thanks. I’ll do this test. During starting attempts I can see some fuel coming from the slide needle (I think it shows in the videos...
So I have to spray it in the idle jet and make sure it comes out from those little holes where the throttle valve is? Sorry for silly questions...
Will do as soon as I finish to check all the pieces, I want to clean the choke valves and grease them (the only part I didn’t clean). Since I got...
I blown compressed air and the slides rise only if I get air into this banana-shaped part pointed with the screwdriver. So are the slides ok?
I removed the carburetors, I'm gonna double check on them. Before that I took some videos of the carburetors during starting attempts: No choke,...
Thanks Captain. I think I reported all my steps in this thread. I didn’t tight the main air jet, didn’t replace the diaphragm or the jet...
I’m sorry, I was tired and didn’t pay attention to what I wrote, I meant the drain screw, does it have to be tightened? The engine doesn’t start,...
The fuel pump works and the fuel filter is new, I think they’re free to go. I will remove the carbs and check everything again. I found almost...
what would you check first? The fuel pump works just fine. Another doubt is point 11 of my first message: is it normal the float bowls have a...
Last time I checked they weren't, tomorrow will check again (here in Italy is 11:10 p.m.) but I doubt because the other day I checked multiple...
Some more: The main air jet doesn't go all the way in like the slow jet: should it go? I measured the float level and I had to set just one of...
Ok, here we go. Yes, I get how to remove them from this YouTube video and how to remove all pieces from this and this video Don't think this...
Ok, give me just a couple of minutes and I’ll be back with every tracks of my actions
Separate names with a comma.
