It's a bit of a ratchet. Kind of like a bad syncro. It's not bad and sometimes the shifts is very smooth when the rpms match just right. It seems...
My '92 shifts a bit noisy from 1st to 2nd. The clutch disengages just fine and there is no issue with the pushrod assembly. I'm pretty easy on the...
Where did you get the boots? You might want to pull the thermostat and give it a check while you're in there. If your bike has a PAIR system you...
Just unbolt the rear footpeg assembly and carefully pull on the cable with some needle nose pliers. IlI' bet the cable is in need of a serious...
I never store any of my engine powered stuff dry. Fill with non ethanol gas, fog the cylinders, set the battery on a maintainer and the bike will...
I removed the oil and dirt soaked foam and taped up the inside of the plastic with aluminum duct tape. Use a putty knife to remove the foam and...
I just replaced the thermostat on my '92 VFR750F. There are two small hoses that go from the thermostat housing to the front and rear cylinders. I...
I did find out that the entire exhaust was manufactured by Two Brothers Racing. Of course they dont support this bike anymore. There is a dent in...
I bought this '92 from my son and he bought it from a guy in Texas. It has less than 10,000 miles on it and shows no signs of major wear or abuse....
I was forced to go aftermarket and make an adapter plate. Works great now.
I just removed the PAIR system from my '92 VFR750F. It was a bit painful to remove the plumbing from the rear cylinders. I remove the shock and...
ABSABS Cem works great for cowling repairs. I usualy back the repair up whith some light glass cloth and some more abs cement. Works great!
What kind of RTV do you use? I typically will use a very small amount of silicon grease on tht hoses but you need to be careful not to use too...
Next time use some silicone grease on the rubber boots. Makes re-assembly and subsequent disassembly way easier.
So much easier on my gen3 carbureted bike. Remove the tank, easy, remove the carbs, easy, remove the rh coil, easy, open up the thermostat...
Howdy, I have a '92 VFR750F. Can I assume its a generation 3? How can i tell?
Hello, I have a 1992 VFR750F with less than 10,000 miles. How can I tell if its gen3 or gen 4?
Separate names with a comma.
