I have an opportunity to get a good VF1000F 85 engine and would like to know if I will have any problem installing it in my VF1000F 84 (both are...
77222-MBG-000 PLUG B RR COWL Bought it in Canada in Sept 2009.
Changed the front sprocket and problem gone.
Finally had time to re-adjust the bearings (and close this thread). Added some slack and wave gone.
Without checking my log book, around 3000 kms. I've been lazy on the maintenance this season. Removed some tension on the chain and it reduced...
When symptom started, I went to adjust the chain, thinking it was too slack. It was just correct. From the millage done since the previous...
Agree for chain adjustment, I was thinking about the effect of hub bearings failure. Standard wheel bearings are easier to check (or at least, I...
Thanks for the feedback. There is a consensus. I always change the 3 parts together but when the chain is due (usually the master link is in worse...
A new vibration appeared on my 5th gen that I can feel through the left foot peg. Not as rough as when the chain is too slack. I can feel it when...
Thanks for your feedback. There is a consensus... on the tightening if not on the (OEM) balls :-)
Thanks camo, I must admit I've been lazy and did it with the fork and wheel installed. I'll redo it with more care, and less torque.
Changed the steering stem ball bearings by tapered roller on my vf1000f and have problem adjusting it. I didn't have the tool for the right torque...
I have CBR600F2 clipons on a vf1000f with cbr1000rr '07 masters (mirrors now mounted on the fairing). I dropped the forks 15mm mainly for handling...
We are talking here 25 years old electronic here. EPROM was erasable using ultraviolet but without using the erasing capablility, was more...
'98 vfr with galfer front rotors and beetle bags. '84 vf1000f with '94 cbr600f2 wheels and clipons, '04 vfr800/a rear shock, racetech gold valve...
Wow, is it the same bike than in the first picture? Lot of TLC since then. I have two of them in my garage and none looks that clean. Can you...
'94 F2 wheels (DMr), '04 VFR800/A rear shock (DMr), Racetech gold valve emulator, '04 F2 clipons, '07 cbr1000rr front master cylinders &...
Problem with this thread is that if a lever fails in the hand of a rider, chances are he would not be able to report on it :-( This being said, I...
This crimping and blue tape is something I also found in vf1000f wiring harness I dismantled. I had the same starting problem with a vf1000f, I...
If you can remove the old seal without removing the rod, then you're ok. But we normally pull it using the fork tube and must first free it by...
Separate names with a comma.
